![background image](http://html1.mh-extra.com/html/daikin/comfort-flex-cliv-series/comfort-flex-cliv-series_installation-operation-and-maintenance-manual_4699236039.webp)
iom-cliv-eng
www.comfort-flex.com
39
Alarms
PRESENT ALARMS PARAMETER MENU
When an alarm occurs within the CLIV equipment the controller
does not have the ability to show directly on the display the
alarm that is present, however this alarm can be checked from
a parameter which by means of a numeric value indicates the
meaning of this alarm within this manual and within the alarm
section you can consult the alarm that is present and to diagnose
what the problem is which does not allow the system to turn on.
This section will show how to enter this parameter and view the
value of the fault that is currently present.
To access the alarm parameter menu follow the steps in this
manual in the example section of menu navigation within the
controller, once these steps are done you must enter the next
screen where you select the favorite menu, then press the dial to
access the next menu and get to the root parameters.
Once the above is done, select the FB1 menu and then press the
dial to enter the root parameters as shown below.
After that, select the PGM1 menu and then press the dial to enter
the root parameters.
After the previous step, turn the dial to the right to find parameter
number 12.
In the previous image this parameter indicates the alarms that are
active; when there is no alarm inside the equipment the parameter
will show a zero and depending on the alarms that exist inside
the system when one of them is activated the system will mark
the priority alarm after that when the alarm is reset and there is
another alarm present it will be shown in this parameter.
Refer to the control parameters section to select the alarm reset
parameter from the menu.
WEB CONNECTION FOR PARAMETER DISPLAY
The Cliv device has a web interface that allows a more detailed
view of the parameters for manipulation and visualization, and
a brief introduction to configure this interface and visualize it if
necessary through a PC.
To be able to make a connection to an ethernet network can
be done in two ways either by connecting the device to a local
network or connecting it to an internet network for either of the
two cases you have to enter the parameters menu to access the
address of the device, the steps to perform this procedure are
shown below.
In the main screen you have to select the configuration menu as
shown in the following screen (to know how to navigate through
the display options see the navigation section of this manual).
After pressing the dial to enter the communications icon
configuration, pin access will be required.
Содержание Comfort Flex CLIV Series
