4
(Adjustable
angle)
45
°
Press the signal
receiver into the
insulated mounting
frame.
1
Press the signal receiver
and mounting frame into
the faceplate frame and
secure with two screws.
2
Mount the
completed
assembly using
two screws.
3
Press the
faceplate onto
the faceplate
frame.
4
Press the
decorative
cover into the
faceplate.
5
Nut (commercially available)
Washer (commercially available)
Tighten
(two nuts)
;
;;;
;;;
;;
;
;;
;;
;;
;
;
Vinyl tube
Water level
INDOOR UNIT INSTALLATION
■
Temporarily install the indoor unit.
●
Attach the hanger brackets to the suspension bolts. Be
sure to use nuts and washers both above and below
the hanger brackets to secure them.
NOTE) Use washers when mounting with M8 bolts.
■
Use a water level or water-filled vinyl tubes to
check that the unit is level at all four corners as
shown in the drawing.
■
Tighten the top nuts.
■
Mounting the signal receiver
Mount the signal receiver as shown below.
Note)
Mount the remote control cord far enough away from strong electrical wires (such as distribution wires for electrical
lights, air conditioners, etc.) and from weak electrical wires (such as wires for telephones, intercoms, etc.).
For heat pump:
If your feet feel cold when using the heating
function, it is recommended that the air
discharge grill shown at right be attached.
OUTDOOR UNIT INSTALLATION
Install as described in the installation manual supplied with the Multi outdoor unit.
Содержание CDXS25BVMB
Страница 11: ...2P098794 3 M02B075 0210 HT...