3P225748-4G English
11
Dust Collection with Vacuum Cleaner
1
Vacuum the dust in the dust box on completion of confirming the dust collection
sign.
NOTE
• Dust collection with a vacuum cleaner is not possible during filter auto-cleaning. Make sure that “
AUTO CLN
FILTER
” is
not displayed on the remote controller screen before dust collection.
* The indicator will flash green if it is set to display. (Refer to page 2)
2
Insert the connecting pipe and attachment (optional accessory) meeting the size of
the vacuum cleaner pipe. The KKHAP55B160 (optional accessory) consists of a
connecting pipe and attachment.
Insert the connecting pipe attachment into the vacuum cleaner pipe.
Vacuum cleaner pipe
Connecting pipe
Vacuum cleaner pipe with an inner
diameter of 1-1/4 (32) to 1-1/2 (38)
Vacuum cleaner pipe with an inner
diameter of 1-1/2 (38) to 1-5/8 (42)
Vacuum cleaner pipe
Attachment
Connecting pipe
in. (mm)
NOTE
• A vacuum cleaner pipe with an air-leaking hole midway or with no round end (i.e., a stand-type or
handheld-type) cannot be used.
• Make sure that the vacuum cleaner has a suction power of 300 W or over.
• Do not use a vacuum cleaner with reduced suction power because the vacuum cleaner is full of dust
inside.
* Neglecting the above may result in poor recovery of dust.
3
Insert the leading end of the connection pipe into the dust collection inlet of the
suction grille underneath. Then push to fit the leading end onto internal air inlet
until the leading end snaps.
in. (mm)
Dust collection inlet
Connection pipe
Rises approximately
3/8 (10)
Internal cross section of dust collection inlet
Air inlet
