Daikin BRC7GA56, Руководство по эксплуатации

Страница: 15 / 19

English 10
Operate in the following order.
• The timer is operated in the following two ways.
Programming the stop time ( )
.... The air conditioner stops operating after the
set time has elapsed.
Programming the start time (
)
.... The air conditioner starts operating after the
set time has elapsed.
• The start and the stop time can be simultaneously
programmed.
• The timer setting is effective only once. When
using the TIMER operation every day, the setting
is required before each use.
For example.
When the timer is pro-
grammed to stop the sys-
tem after 3 hours and start
the air conditioner after 4
hours, the air conditioner
will stop after 3 hours and
then 1 hour later the air
conditioner will start.
NOTE
• After the timer is programmed, the display shows
the remaining time.
When the remote controller does not work due to
battery failure or the absence thereof, use the switch
on the receiving unit of the indoor unit. When the
remote controller does not work, even if the batteries
air replaced, contact your local dealer.
PROGRAM TIMER OPERATION
TIMER MODE START/STOP
Press the TIMER MODE START/STOP
BUTTON several times and select the
mode on the display.
The display flashes.
For setting the timer stop .... “
”
For setting the timer start .... “ ”
PROGRAMMING TIMER
Press the PROGRAMMING TIMER BUT-
TON and set the time for stopping or start-
ing the air conditioner.
• Keep pressing the button to change the setting
time continuously.
• The timer can be programmed a maximum of
72 hours.
1 TIMER
2
DOWN
UP
When this button is pressed, the time
advances by 1 hour.
When this button is pressed, the time
goes backward by 1 hour.
DOWN
UP
TIMER RESERVE
Press the TIMER RESERVE BUTTON.
The timer setting procedure ends.
The display changes from flashing light to a con-
stant light.
• Make sure that the receiving tone of the indoor
unit makes a beeping sound.
If the receiving tone does not sound, press the
TIMER CANCEL BUTTON, and then set the
timer using steps to again.
TIMER CANCEL
Press the TIMER CANCEL BUTTON to cancel
programming.
The display vanishes.
• Make sure that the receiving tone of the indoor
unit makes a beeping sound. If the receiving
tone does not sound, set the timer using steps
to , and then press the TIMER CANCEL
BUTTON again.
EMERGENCY OPERATION
3 RESERVE
1 3
4
CANCEL
1 3
MODE
TIMER
RESERVE CANCEL
DOWN
UP
FAN
TIME
TEMP
ON OFF
C
hr.
hr.
01_EN_3P302565-2D.fm Page 10 Sunday, September 30, 2012 1:30 PM