Daikin AZAS100M7V1B, Руководство по установке для специалистов

Страница: 20 / 32

6 Installation
Installer reference guide
20
AZAS71~Y1
Sky Air Active-series
4P486048-1A – 2017.08
6.7.4 Guidelines when connecting the electrical
wiring
Keep the following in mind:
▪ If stranded conductor wires are used, install a round crimp-style
terminal on the end of the wire. Place the round crimp-style
terminal on the wire up to the covered part and fasten the terminal
with the appropriate tool.
b a
a Stranded conductor wire
b Round crimp-style terminal
▪ Use the following methods for installing wires:
Wire type Installation method
Single-core wire
c b
c
a a
A
AA´
A´
a Curled single-core wire
b Screw
c Flat washer
Wire type Installation method
Stranded conductor
wire with round
crimp-style terminal
c b b a c
a
B
B
a Terminal
b Screw
c Flat washer
O Allowed
X Not allowed
Tightening torques
Item Tightening torque (N•m)
M4 (X1M) 1.2~1.8
M4 (earth) 1.2~1.4
M5 (X1M) 2.0~3.0
M5 (earth) 2.4~2.9
If limited space is available at the wire terminal, use bended crimp-
style ring terminals.
6.7.5 Specifications of standard wiring components
Component V1 Y1
71 100 125 140 100 125+140
Power supply cable MCA
(a)
17.5 A 21.8 A 28.3 A 27.6 A 14.6 A 15.1 A
Voltage range 220~240 V 380~415 V
Phase 1~ 3N~
Frequency 50 Hz
Wire sizes Must comply with applicable legislation
Interconnection cables Minimum cable section of 2.5 mm² and applicable for 230 V
Recommended field fuse 20 A 25 A 32 A 16 A
Earth leakage circuit breaker Must comply with applicable legislation
(a) MCA=Minimum circuit ampacity. Stated values are maximum values (see electrical data of combination with indoor units for exact values).
6.7.6 To connect the electrical wiring on the
outdoor unit
NOTICE
▪ Follow the wiring diagram (delivered with the unit,
located at the inside of the service cover).
▪ Make sure the electrical wiring does NOT obstruct
proper reattachment of the service cover.
1 Remove the service cover. See "6.2.2 To open the outdoor
unit" on page 11 .
2 Strip insulation (20 mm) from the wires.
a b
a Strip wire end to this point
b Excessive strip length may cause electrical shock or
leakage.
3 Connect the interconnection cables and power supply as
follows: