![background image](http://html.mh-extra.com/html/daikin/arxm25m3v1b9/arxm25m3v1b9_installation-manual_501325011.webp)
English
9
Pump Down Operation
In order to protect the environment, be sure to pump down when relocating or disposing of the unit.
1) Remove the valve cap from liquid stop valve and gas stop valve.
2) Carry out forced cooling operation.
3) After 5 to 10 minutes, close the liquid stop valve with a hexagonal wrench.
4) After 2 to 3 minutes, close the gas stop valve and stop forced cooling operation.
Forced cooling operation
Using the indoor unit ON/OFF switch
Press the indoor unit ON/OFF switch for at least 5 seconds. (The operation will start.)
• Forced cooling operation will stop automatically after around 15 minutes.
To stop the operation, press the indoor unit ON/OFF switch.
Using the indoor unit’s remote controller
Perform the test operation with the operation mode set to cooling. For the test operation procedure read the installation manual
attached to the indoor unit and the manual of the remote controller.
• Forced cooling operation will stop automatically after around 30 minutes.
To stop the operation, press the ON/OFF button.
CAUTION
If used forced cooling operation and the outside temperature is -10°C or lower, the safety device might start, preventing opera-
tion. In this situation, warm the outside temperature thermistor on the outdoor unit to -10°C or warmer. Operation will start.
CAUTION
• During pump down operation, do not touch the terminal block. It has a high voltage, so doing so may cause electric shock.
• After closing the liquid stop valve, close the gas stop valve within 3 minutes, then stop the forced cooling operation.
Liquid
stop valve
Gas
stop valve
Service port
Valve cap
Close
Hexagonal
wrench
WARNING
The unit is accompanied with the label below. Please read the following instructions carefully.
WARNING
1)
2)
3)
4)
5)
• When the refrigeration circuit has a leak, do not execute pump down with the compressor.
• Use recovery system into separate cylinder.
• Warning, explosive hazard exists when executing pump down.
• Pump down with compressor can lead to self-combustion due to air entering during pump
down.
Used symbols:
1)
Warning sign (ISO 7010 – W001)
2)
Warning, Explosive material (ISO 7010 – W002)
3)
Read Operator’s manual (ISO 7000 – 0790)
4)
Operator’s manual; operating instructions (ISO 7000 – 1641)
5)
Service indicator; read technical manual (ISO 7000 – 1659)
3PEN386697-3G.book Page 9 Monday, April 24, 2017 11:02 AM
Содержание ARXM25M3V1B9
Страница 17: ...3PEN386697 3G book Page 1 Monday April 24 2017 11 02 AM ...
Страница 18: ...3PEN386697 3G book Page 2 Monday April 24 2017 11 02 AM ...
Страница 19: ...3PEN386697 3G book Page 3 Monday April 24 2017 11 02 AM ...
Страница 20: ...3P386697 3G 2017 03 Copyright 2017 Daikin 3PEN386697 3G book Page 1 Monday April 24 2017 11 02 AM ...