Dahua VTO2202F-P, Быстрая установка, Страница: 7 / 12

7
The VTH Confi g menu is used to set the room number of the VTH and to confi gure the unit as a Master or Extension unit. If only a single
VTH is being used in the system, then this should be set to Master and a room number chosen. Adding extension VTH units is covered
on page 9. Note: Master monitor must have #0 after the room number.
In the settings menu select SIP to confi gure the VTH SIP settings. Enter the IP address of the VTO and also a register password of your
choosing, it is important to remember this password as it will be used again later.
For both the VTO and VTH to communicate, each unit must have the IP address details of the other unit. To add the VTO unit to the
VTH, select VTO Confi g and input the VTO units IP address, Username & Password then set Enable Status to ON.
Set Enable Status to ON and tap OK