WEB Client 56
General system settings
Configure parameters according to actual requirement. Please refer to Table 5-20 for
more details.
Table 5-20 General parameters description
Parameter Note
Brightness
It is used to adjust the overall image brightness, change the value when the
image is too bright or too dark.
The bright and dark areas will have equal changes. The image becomes blurry
when the value is too big. The recommended value is from 40 to 60. The range
is from 0 to 100.
The default value is 50. The bigger the value is, the brighter the image becomes.
Contrast
Change the value when the image brightness is proper but contrast is not
enough.
If the value is too big, the dark area is likely to become darker and the bright
area is likely to be overexposed.
The picture might be blurry if the value is set too small. The recommended
value is from 40 to 60 and the range is from 0 to 100.
The default value is 50. The bigger the value is, the more obvious the contrast
between the bright area and dark area will become.
Hue
It is used to adjust the image hue. For example, change red into blue. The
default value is made by the light sensor and normally it doesn’t have to be
adjusted. The recommended value is from 40 to 60 and the range is from 0 to
100.
The default value is 50. The threshold is used to adjust image hue and ot will not
influence image overall brightness.
