Dahua HCVR7416L, Руководство пользователя

Страница: 121 / 330

111
4.5.3 PTZ Control
The PTZ setup is shown as in See Figure 4-20.
Please note the commend name is grey once device does not support this function.
The PTZ operation is only valid in one-window mode.
Here you can control PTZ direction, speed, zoom, focus, iris, preset, tour, scan, pattern aux function,
light and wiper, rotation and etc.
Speed is to control PTZ movement speed. The value ranges from 1 to 8.The speed 8 is faster than
speed 1. You can use the remote control to click the small keyboard to set.
You can click and of the zoom, focus and iris to zoom in/out, definition and brightness.
The PTZ rotation supports 8 directions. If you are using direction buttons on the front panel, there are
only four directions: up/down/left/right.
Figure 4-20
In the middle of the eight direction arrows, there is a 3D intelligent positioning key. See Figure 4-21.
Please make sure your protocol supports this function and you need to use mouse to control.
Click this key, system goes back to the single screen mode. Drag the mouse in the screen to adjust
section size. The dragged zone supports 4X to 16X speeds. It can realize PTZ automatically. The
smaller zone you dragged, the higher the speed.
Figure 4-21
Name Function
key function Shortcut
key Function
key function Shortcut
key
Zoom Near Far

Focus Near
│ 
Far
► │
Iris close


Open


In Figure 4-20, click to open the menu, you can set preset, tour, pattern, scan and etc. See
Figure 4-22.