Darim PVE400 Quick Start Manual Download

Page: 1 / 4

PVE400 Quick Start Guide

Connect the Bullet Camera to the camera connector

(4)

– the white guide markings on the

PVE interface and camera interface should be lined up. If there are no white alignment
dots, simply rotate until it mates.

Attach the Antenna to RP-SMA connector

(2)

Press and hold the

Power button

(1)

until

Green Power On

LED

(5)

is on.

The unit will take approximately 60 seconds to fully boot at which point it is ready for
operation. The

Green

Status LED

(6) will indicate that unit is ready.

Connect PVE-AUX cable to the AUX connector

(3)

and RG45 side to the PC or switch.

PVE-AUX cable is “straight” Ethernet cable and must be connected through a
hub/switcher unless your computer has autosensing Ethernet port.

Summary of Contents for PVE400

Page 2: ...1 100 7 By default the wired PVE400 Ethernet port is configured with a static IP address 192 168 1 250 By utilizing the PVE AUX cable you can access the PVE400 and configure the network settings a v settings and diagnostics using the web management interface by launching the Internet Browser session to http 192 168 1 250 ...

Page 3: ...ting the user account should appear The factory default account is User admin Password admin then the PVE400 Web Management Interface opens Note you may use any Internet Browser for configuration but the embedded video plug in will work only with the Microsoft Internet Explorer on Windows based OS ...

Page 4: ...o your wireless router For example 10 Select the VIDEO tab and you will be asked if you want to install the Active X plug in 11 Confirm acceptance and when installed you will be able to view live video from the PVE unit via the Darim s Active X plug in on the VIDEO tab 12 To turn off press and hold the power button 1 until green Power LED 5 is off ...