5
Figure 3-4
Mode 2
Installation diagram is shown in Figure 3-5.
Figure 3-5
Step 1 Fix the U-shaped guide rail onto the wall with screws.
Step 2 Buckle the upper rear part of the device into upper groove of U-shaped guide rail.
Step 3 Push the snap joint at the bottom of the device upwards. The installation is completed
when you hear the fitting sound.
3.4
Disassembly
If the device is installed with mode 2, please disassemble it according to Figure 3-6.
Align a screwdriver with the snap joint, press it down and the snap joint will pop up, so the