12
4.3 Mounting the Camera to a Wall
1. Place the PFB303W Wall Mount against the wall and mark the location of the center hole and
mark the four (4) perimeter mounting holes.
2. Pre-drill the four perimeter holes as marked on the wall for the expansion bolts, using a drill bit
that is no wider than the expansion bolt.
3. Drill a 50-mm (approximately 2 in.) center hole to route the cables, if necessary.
4. Insert an M8 expansion bolt into each pre-drilled perimeter hole.
5. Remove the M4 Stainless Screw from the front of the PFB303W Wall Mount Bracket.
6. Wrap several turns of Teflon tape around the threads on the PFA111 Mount Adapter (with Quick
Installation Port) and screw the Mount Adapter into the Wall Mount Bracket.
Figure 4-3
7. Secure the mount adapter quick installation port to the wall mount bracket with the M4 Stainless
Screw.
8. Route the incoming cables through the wall or through the metal conduit, then through the wall
mount bracket.
9. Secure the wall mount bracket to the wall using four M6 x 15 screws with the four (4) hex screws
and four (4) flat washers.
