DRPB48V Operation Manual
4) Use the
oil injector (in the accessories pack)
to slowly inject the oil until full (approx. 15ml).
Remove the injector and its adaptor, then clean off any excess oil on the tool and tightly
screw the
screw (#11)
back into the tool;
5) Test the tool stroke. If the stroke is still not what it should be, some air could have entered
the
oil cylinder (#13)
while refilling the oil in the tool. To release this extra air from the tool,
connect the tool to the air supply, pull the tool
trigger (#48)
6 or 7 times, then loosen the
screw (#11)
, to let the extra air leak out and then tighten the
screw (#11)
again.
