4-12 Inspection, Maintenance and Adjustment
022-00028AE Operation and Maintenance Manual
FILL FUEL TANK
1.
At end of each work day, fill fuel tank. Add
fuel through fuel filler pipe (Figure 14).
When working at a temperature of 0°C
(32°F) or higher, use ASTM No. 2-D or its
equivalent. At temperatures below 0°C
(32°F) use ASTM No. 1-D or its equivalent.
NOTE:
See “Fluid Capacities” on
page 4-5 for capacity.
2.
Securely tighten cap after fueling.
NOTE:
If breather holes in cap are
clogged, a vacuum may form in
the tank preventing proper fuel
flow to engine. Keep holes in
fuel cap clean.
CHECK FOR LEAKS IN THE FUEL SYSTEM
1.
Perform an inspection of engine
compartment to verify that fuel system is
not leaking. If any is noted, determine the
source of leak and repair.
WARNING!
Use extreme safety precautions while
refueling to prevent explosions or fire.
Immediately clean up any spilt fuel.
Figure 14
HAOC510L
Figure 15
