5
This appliance must be earthed. In the event of an electrical short circuit,
earthing reduces the risk of electric shock by providing an escape wire
for the electric current. This appliance is equipped with a cord having a
earthing wire with an earthing plug. The plug must be plugged into an
outlet that is properly installed and earthed.
INSTALLATION
EARTHING INSTRUCTIONS
WARNING :
Improper use of the earthing plug can result in a risk
of electric shock. Consult a qualified electrician or service engineer if the
earthing instructions are not completely understood, or if doubt exists as
to whether the appliance is properly earthed. If it is necessary to use an
extension cord, use only a 3-wire extension cord that has a 3-blade
earthing plug, and a 3-slot receptacle that will accept the plug on the
appliance. The marked rating of the extension cord should be equal to or
greater than the electrical rating of the appliance.
3. Leave space behind and side
All air vents should be kept a clearance. If all vents are covered during
operation, the oven may overheat and, eventually, oven failure.
4. Away from radio and TV sets
Poor television reception and radio interference may result if the oven is
located close to a TV, Radio antenna, feeder and so on. Position the
oven as far from them as possible.
5. Away from heating appliance and water taps
Keep the oven away from hot air, steam or Splash when choosing a
place to position it, or the insulation might be adversely affected and
breakdowns occur.
6. Power supply
• Check your local power source. This oven requires a current of
approximately 6 amperes, 240V 50Hz.
• Power supply cord is about 0.8 meters long.
• The voltage used must be the same as specified on this oven. Using a
higher voltage may result in a fire or other accident causing oven
damage. Using low voltage will cause slow cooking. We are not
responsible for damage resulting from use of this oven with a voltage of
ampere fuse other than those specified.
• If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or a similarly qualified persons in order to avoid a
hazard.
7. Examine the oven after unpacking for any damage such as:
A misaligned door, Broken door, A dent in cavity. If any of the above is
visible, DO NOT INSTALL, and notify dealer immediately.
8. Do not operate the oven if it is colder than room temperature.
(This may occur during delivery in cold weather.) Allow the oven to
become room temperature before operating.
1. Ventilation
Do not block air vents. If they are blocked during operation, the oven may
overheat and eventually cause a failure. For proper ventilation, allow
above 100mm of space between oven sides, rear and the minimum
height of free space necessary above the top surface of the oven is
200mm.
2. Steady, flat location
This oven should be set on a steady, flat surface. This oven is designed
for counter top use only.
The microwave oven shall not be placed in a cabinet unless it has been
tested in a cabinet.
KOR9LBKW,KOR9LBKR,KOR9LBKC,KOR9LBKBL,KOR9LBKM_KOR669R(영)_가로A5.indd 5
2017-11-24 오전 11:17:27