KOR-9GPB _
26
KOR-9GPB _
27
SAFETY
»E
arthing Instructions
»I
NSTALLATION
This appliance must be earthed. In the event of an electrical
short circuit, earthing reduces the risk of electric shock by
providing an escape wire for the electric current. This
appliance is equipped with a cord having a earthing wire with
a earthing plug.
The plug must be plugged into an outlet that is properly
installed and earthed.
WARNING
: Improper use of the earthing plug can result in a
risk of electric shock. Consult a qualified electrician or
serviceman if the earthing instructions are not completely
understood, or if doubt exists as to whether the appliance is
properly earthed.
If it is necessary to use an extension cord, use only a 3-wire
extension cord that has a 3-blade earthing plug, and a 3-slot
receptacle that will accept the plug on the appliance. The
marked rating of the extension cord should be equal to or
greater than the electrical rating of the appliance.
IMPORTANT
The wires in this mains lead fitted to this appliance are
colored in accordance with the following code.
Green-and-yellow : Earth
Blue : Neutral
Brown : Live
As the colors of the wires in the mains lead of this appliance
may not correspond with the colored markings identifying the
terminals in your plug, proceed as follows : the wire which is
colored green-and-yellow must be connected to the terminal
in the plug which is marked with the letter 'E' or by the earth
symbol or green-and-yellow. The wire which is colored blue
must be connected to the terminal which is marked with the
letter 'N' or colored black. The wire which is colored brown
must be connected to the terminal which is marked with the
letter 'L' or colored red.
WARNING :
The appliance must be earthed.
1. Ventilation
Do not block air vents. If they are blocked during operation,
the oven may overheat and eventually cause a failure. For
proper ventilation, allow above 76mm of space between
oven sides, rear and the minimum height of free space
necessary above the top surface of the oven is 150mm.
2. Steady, flat location
This oven should be set on a steady, flat surface. This oven
is designed for counter top use only.
The microwave oven shall not be placed in a cabinet unless
it has been tested in a cabinet.
3. Leave space behind and side
All air vents should be kept a clearance.
If all vents are covered during operation, the oven may
overheat and, eventually, oven failure.
4. Away from radio and TV sets
Poor television reception and radio interference may result
if the oven is located close to a TV, Radio antenna, feeder
and so on. Position the oven as far from them as possible.
5. Away from heating appliance and water taps
Keep the oven away from hot air, steam or Splash when
choosing a place to position it, or the insulation might be
adversely affected and breakdowns occur.
6. Power supply
• Check your local power source. This oven requires a
current of approximately 6 amperes, 220-240V 50Hz.
• Power supply cord is about 0.8 meters long.
• The voltage used must be the same as specified on this
oven. Using a higher voltage may result in a fire or other
accident causing oven damage. Using low voltage will
cause slow cooking. We are not responsible for damage
resulting from use of this oven with a voltage of ampere
fuse other than those specified.
• If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified
person in order to avoid a hazard.
7. Examine the oven after unpacking for any damage such
as:
A misaligned door, Broken door, A dent in cavity.
If any of the above are visible, DO NOT INSTALL, and notify
dealer immediately.
8. Do not operate the oven if it is colder than room
temperature.
(This may occur during delivery in cold weather.) Allow the
oven to become room temperature before operating.
DESUK_KOR-9GPB7S42.indd 29
2014-05-27 오후 2:59:56
