15
(1) Remove the gasket door
¤
from door plate.
(2) Remove the barrier screen inner
¤Ł
from door plate.
(3) Remove the door frame
¤Ø
from door plate.
(4) Remove the spring
¤º
and the hook
¤Œ
.
(5) Remove the barrie screen outer
¤
from door frame
¤Ø
(6) Reverse the above steps for reassembly.
4. Method to reduce the gap between the door seal and the oven front surface.
(1) To reduce gap located on part ‘ A ’.
1) Loosen twon screws on stopper hinge top, and then
push the door to contact the door seal to oven front
srface.
2) Tighten two screws.
(2) To reduce gap located on part ‘ B ’.
1) Loosen two screws on bottom hinge, and then push the door to oven front surface.
2) Tighten two screws.
(3) To reduce gap located on part ‘ C ’ (See Fig. A)
1) Loosen a screw on the interlock switch assembly located at the bottom of the oven body.
2) Draw the interlock switch assembly inward as possible to engage with hook on the bottom side.
3) Tighten a screw.
(4) To reduce gap lacated on part ‘ D ’ (See Fig. B)
1) Loosen a screw on the interlock switch assembly located at the top of the oven body.
2) Follow step 2) and 3) of (3).
NOTE
: A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm
2
.
PRIMARY
INTERLOCK
SWITCH
INTERLOCK
MONITOR
SWITCH
HOOK
SECONDARY
INTERLOCK
SWITCH
HOOK
B
C
A
D
