![background image](http://html1.mh-extra.com/html/daewoo/kom-9p2cbs/kom-9p2cbs_service-manual_3557496013.webp)
12
4. Method to reduce the gap between the door seal and the oven front surface.
(1) To reduce gap located on part ‘A’
• Loosen two screws on the stopper hinge top, and then
push the door to contact the door seal to the oven front sur-
face.
• Tighten two screws.
(2) To reduce gap located on part ‘B’
• Loosen two screws on the stopper hinge under, and then
push the door to contact the door seal to the oven front sur-
face.
• Tighten two screws.
(3) To reduce gap located on part ‘C’
• Loosen the screw on the interlock switch assembly located
the top of the oven body.
• Draw the interlock switch assembly inward as possible to
engage with the hook on the door bottom.
• Tighten a screw.
(4) To reduce gap located on part ‘D’
• Loosen the screw on the interlock switch assembly located
the bottom of the oven body.
NOTE : A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm
2
.
Содержание KOM-9P2CBS
Страница 5: ...4 1 OUTER DIMENSION EXTERNAL VIEW 542 461 329...
Страница 26: ...25 WIRING DIAGRAM...
Страница 28: ...27 Measure Point MP1 MP2...
Страница 30: ...29 DMR 1P5FS 2 PCB CIRCUIT DIAGRAM...