Before the first time you use your Stove Effect Heater
Please read these operating instructions thoroughly and keep them in
a safe place for future reference.
Remove all packing materials and discard responsibly.
Operating Instructions – heat setting
•
Place the heater on a solid, level non-flammable surface.
•
To reveal the controls open the flame effect door.
• Ensure that all control switches are in the off.
• Insert the mains plug into the mains socket.
•
For heat and flame effect press the ON/OFF switch to ON.
• Rotate the thermostat control clockwise to increase the room tem-
perature and anticlockwise to decrease the room temperature as
desired.
•
The flame effect can be dimmed and brightened using the dimmer
control.
Hint on setting the correct temperature
• Set the heater to the desired heat setting as above.
•
Rotate the Thermostat to the maximum position and allow the
room to warm up. Once the desired room temperature has
been reached turn the Thermostat anticlockwise until the heat-
er just clicks off then turn it back up clockwise very slightly. The
Thermostat will now maintain the room temperature, if necessary,
further increasing or decreasing the thermostat control may be
required to ‘fine tune’ the ideal room temperature.
Care and Use of your Stove Effect Heater
1. Always disconnect the stove effect heater from the mains power
supply and allow to cool before cleaning.
2. Clean outside of the heater with a clean damp cloth. Never clean
with harsh or abrasive cleaners.
3. Do not submerge any part of the stove effect heater in water or any
other liquids.