Insert the mains plug into the mains socket.
For the low heat setting, rotate the On/Off/Fan/Heat Switch (2) to the low
heat position (I).
For the high heat setting, rotate the On/Off/Fan/Heat Switch (2) to the high
heat position (II).
Rotate the thermostat control (3) clockwise to increase the room
temperature and anticlockwise to decrease the room temperature as
desired.
NB
the Indicator (4) will illuminate on and off to indicate that the set
temperature is being maintained.
Return the on/off/fan/heat switch (2) to the
(O) position to switch off the
heater.
Hint on setting the correct temperature
Set the heater to the desired heat setting as above.
Rotate the Thermostat to the maximum position and allow the room to
warm up. Once the desired room temperature has been reached turn the
Thermostat anticlockwise until the heater just clicks off then turn it back up
clockwise very slightly. The Thermostat will now maintain the room
temperature, if necessary, further increasing or decreasing the thermostat
control may be required to ‘fine tune’ the ideal room temperature.
Return the on/off/fan/heat switch (2) to the
(O) position to switch off the
heater.
Fan Only Mode
Rotate the On/Off/Fan/Heat Switch (2) to the fan only position ( ) to
enable the fan to operate for cool air output.
NB
the thermostat control will
need to be rotated to the fully clockwise position for the fan to operate.
Care and Use of your Fan Heater
Always disconnect the heater from the mains power supply and allow to
cool before cleaning.
Clean outside of the heater with a clean damp cloth. Never clean with
harsh or abrasive cleaners.
Do not submerge any part of the heater in water or any other liquids.
Safety Cut
– Out
Warning:
This appliance is fitted with a built in safety cut-out, if the cut-
out is activated the unit stops working, unplug the heater from the mains and
check that the air intake area is not blocked or covered.
Leave for an hour to cool and reset before plugging back into the mains.