INSTALLATION METHOD
Hold the connector in one hand and press the
snap ring in the other hand to pull down to
separate the connector from the tee joint.
1
Loosen the four fixing screws on the connector
and rotate the tightener so that there is sufficient
distance between the tightener and the connector
(the height of 3 threads) for screw installation.
If the pipe diameter of the faucet is too thick, the plastic
guide sleeve inside can be removed.
Screws near the wall can be screwed in a little in advance.
Please select standard faucet. The faucet mouth must
be flat. If it is uneven, please flatten it.
Connector assembly
Plastic guide sleeve
Connector
Tightening device
Retaining ring
Tee joint
water faucet
Tightening device
less than 3mm
the water inlet pipe
2
Evenly adjust the four screws of the connector
so that the two screws close to the wall first fully
contact the outside of the faucet.
3
Press the connector against the faucet port to
make its internal gasket fully contact with the
faucet (please note that the gasket cannot be
taken out).
4
As shown in the figure, rotate the two screws on
the opposite side of the wall to make them
contact with the faucet, and then tighten them
with a screwdriver.
5
Rotate the tightener until the tightener is tightened
(water leakage will occur if it is not tightened).
After rotation, the gap between the tightener and
the connector is less than 3mm.
6
small
big
Wall
Insert the water inlet pipe into the connector, be sure to insert it to the bottom and snap the retaining ring.
7
|
7
|