14
Cleaning the drawer housing
Use a bottle brush to remove detergent residues inside the drawer housing.
Cleaning the water inlet filter
Use pointed nose pliers to withdraw the plastic filter. Clean, put back and secure.
These filter should be checked every 6 months or so, or more often if there are
frequent interruptions to the water supply.
NOTE :
The filter must be put back in place after cleaning.
Important:
If the machine is exposed to temperatures below 0°C, certain precautions should be taken.
1. Turn off the water tap.
2. Unscrew the inlet hose.
3. Unhook the drain hose from the rear support and position the end of this hose and that of the inlet hose in
a bowl. Run the spin programme.
4. Disconnect the appliance.
5. Screw the inlet hose and reposition the drain hose.
6. When you intend to start the machine up again, make sure that the room temperature is above 0°C.
Cleaning the drain pump filter
1. Disconnect the machine from
the mains electricity supply and
open the pump cover with a
screwdriver.
2. Place a container under the
pump. Unscrew and remove
the filter.
3. Clean the filter carefully.
NOTE :
The filter should be cleaned every 2 months or so, or when there is fault that the “Rinse” and “Spin”
LEDs flicker.
DWD-GM1011_영국향.indd 15
2013-09-23 오전 11:42:02
