At the end of every washing:
• Switch off the electricity of the power point.
• Check that both timers are set to the “O” position.
• Wipe off spillage (detergent powder,etc.), and generally wipe over the tub and base with a dry duster.
■
Cleaning after use will extend the life of your washing machine. Before cleaning disconnect the power
cord from the electrical outlet.
• Dirt maybe also collected underneath the pulsator.
• Clean out occasionally by remove the screw located in the
center of the pulsator.
• Hook the pulsator and pull upwards.
• Wash off the lint stuck on the bottom of the wash tub.
(When replacing the pulsator, make sure that the screw must be firmly tightened)
Overflow Filter and Lint Filter
Pulsator
CLEANING AND MAINTENANCE
• Use a screwdriver to loosen the screw of the pulsator, and remove the pulsator.
• Remove the drain strainer from the bottom of the tub using a sharp tool such as a driver.
• Wash off the lint stuck in the strainer.
• Re-install the drain strainer and pulsator.
Drain Strainer
• Remove the overflow Filter by pulling it forward.
• Wash off the lint stuck on the overflow Filter
during overflowing.
• Re-install the overflow Filter: By first inserting its
bottom section and then pushing the upper part
firmly into place.
• If the dregs are piled up in the lint filter after
finishing the wash, push down and pull it out as
shown in figure.
• Remove the collected lint and wash the filter
net.
A
!
@
6
DW-6510(¿ )-Dema
01.3.26
9:21
PM
˘
`
6
