Daewoo DTM-2930MP, Руководство по обслуживанию, Страница: 9 / 66

ALIGNMENT INSTRUCTIONS
4.4 USER GUIDE
4.4.1 ENTERING FACTORY MODE
To switch the TV set into FACTORY mode, use the factory remote control, and press on “SVC” .
The factory menu will appear on the screen, showing “FACTORY Vx,xx”(where x.xx is the
software version).
4.4.2 ENTERING OPTION BITS MENU
To find the option bits, push the button “OPT” once. To find OPTION2 press the button “OPT” a
second time.
4.4.3 SELECTING OPTION BITS
From left to right, bits 7 to 0 are shown. Navigation is done from the with FACTORY remocon
with the VOL MIN and VOL MAX buttons(otherwise known as EAST, WEST). The selected bit is
highlighted.
4.4.4 TOGGLING OPTION BITS
This is done by using the PR UP and PR DOWN button (otherw ise known as NORTH,
SOUTH).
4.4.5 EXTING OPTION BITS MENU
Push the button “OPT” a third time. The full sequence enter to exit is;
FACTORY -> OPTION 1 -> OPTION2 -> OPTION3 -> FACTORY
4.4.6 AFTER SETTING OPTION BITS
Before pushing on the shipping key, “BRI.” , it is necessary to push the “NORMAL” key to obtain
NORMAL I. This will reset all the sound and brightness settings to a factory defined level, as
well as some other settings such as sound PRESET and WAKE TIME/PROG.
Then, on pushing the shipping key, thess levels are memorised in the television, ready for
packing and delivery.
4.4.7 VERIFICATION
On pushing the shipping “BRI.” key, a four digit hexadecimal number is displayed in addition to
“SHIPPING” . This number is there to verify the option bits setting that has been entered. For
example the binary code 1001 1111(OPTION3) 0000 0111(OPTION2) 1100 0010(OPTION1)
will give 9F 07 C2 hex. The order of display is therefore OPTION3, OPTION2 then OPTION 1
when reading from left to right.