5
Fast R, G, B insertion : The external R, G, B insertion needs a fast switching and cannot be controlled by the software (
instruction cycle of 1
µ
sec ). The fast switching pin 16 of SCART is directly connected to the TV processor pin 45 ( Fast
blanking input ). The display is synchronised with the selected video source, i.e. to get stable R, G, B signal insertion they
must be synchronised with the selected video source.
4.
µ
-Controller I/O pin configuration and function
The I/O pins of the
µ
-Controller can be configured in many ways. All port functions can be individually programmed by the con-
trolling software.
Each I/O port pin can be individually programmed in these configurations :
Open drain
In this mode, the port can function as input and output. It requires an external pull-up resistor. The maximum allowable supply
voltage for this pull up resistor is +5V.
So in this mode it is possible to interface a 5 Volt environment like I2C while the
µ
-Controller has a 3.3 Volt supply.
Push-Pull
The push pull mode can be used for output only. Both sinking and sourcing is active, which leads to steep slopes. The levels are
0 and Vddp, the supply voltage 3.3Volts.
High impedance
This mode can be used for input only operation of the port.
Special port for LED
Pin 10 and 11 have the same functionality as the general I/O pins but in addition, their current source and sink capacity is 8 mA
instead of 4 mA. These pins are used for driving LED’s via a series current limiting resistor.
µ
-Controller I/O pin configuration and function table
pin
name
configuration
description
Stand by
TV ON
1
n.u.
High impedance
High impedance
not used
2
SCL
Open Drain
Open Drain
Serial clock line
3
SDA
Open Drain
Open Drain
Serial data line
4
SECAM L’
High impedance
Push Pull / High imped-
ance
SIF filter swi AM/FM
switching
5
OCP
High impedance
High impedance
Over Current Protection (
Switch the set OFF if the volt-
age on this pin is <2.3V )
6
RF AGC in
High impedance
High impedance
Used during ATSS to measure
RF signal level.
7
Key in
High impedance
High impedance
Local keyboard input
8
S/SW
High impedance
High impedance
external video switch
10
Red LED
High impedance
Open Drain
11
Green LED
Open Drain
High impedance
62
Audio mute
Push Pull
High impedance
APPENDIX
ALIGNMENT INSTRUCTIONS
All manuals and user guides at all-guides.com
Содержание DTA-14C4TFF
Страница 4: ...3 Pin EURO SCART SPECIFICATIONS All manuals and user guides at all guides com ...
Страница 38: ...19 IC DESCRIPTION APPENDIX All manuals and user guides at all guides com ...
Страница 41: ...22 APPENDIX IC DESCRIPTION All manuals and user guides at all guides com a l l g u i d e s c o m ...
