Setting up the speaker tower - Attaching the base
1. Take the tower body and base carefully out of the packaging.
2. Take the screws and washers out.
3. Attach the base to the body aligning the holes on the base with the holes on the tower.
4. Screw the base onto the main unit.
5. Place the tower upright on the fl oor and it is now ready to use
Power setup
Connect the AC/DC adapter to the DC in socket on the speaker back panel and plug the
adaptor into the mains socket.
Using the remote control
The battery
To get your remote control working initially, pull the clear tab from
the battery compartment located at the bottom of the remote.
If your remote becomes intermittent or you fi nd you have to move
closer the unit to operate, then probably batteries need to be
replaced.
To replace batteries, slide the holder out from the base of the
remote. Remove the battery and replace with a 3 volt Lithium
CR2025.
Aux-In line in type
Requires a 3.5mm cable (included).
1. When the Tower is powered on, press “STANDBY”, then entering into the AUX mode
automatically.
2. Connect a 3.5mm cable to the Aux-in jack at the rear. Connect the other end of the
3.5mm cable to an MP3 player or other audio source.
3. Use the controls on the top panel to begin playing audio routed through the unit or
press “AUX” button on the remote.
