Daewoo DP-42GM, Руководство по обслуживанию

Страница: 47 / 124

-47-
SET Disassemble/Assemble Method
P302~P304, PA603) Detach iron support Unscrew screws
(8)CONN-LEFT PCB (refer to FIG<6>, FIG<8>, FIG<11>)
Detach STAND from PDP SET Lay PDP SET in a stable place Detach JACK PCB
Detach Stand holding iron structures (LEFT & RIGHT) Detach Connecting Connector
(PC5~PC7, P304A, PC08A) Unscrew screws
(9)CONN-RIGHT PCB (refer to FIG<6>, FIG<8>, FIG<11>)
Detach STAND from PDP SET Lay PDP SET in a stable place Detach JACK PCB
Detach Stand holding iron structures (LEFT & RIGHT) Detach Connecting Connector
(PC1~PC4, P202, P302A~P303A, PC8A1) Unscrew screws
(10)KEY PCB (refer to FIG<8>)
Unscrew screws
(11)AC SWITCH & LED PCB (refer to FIG<10>, FIG<13>)
(Warning) Careful not to break Panel Gas Exhaust Tube!!!
Unscrew screws
(12)Assembling procedure is in the reversing sequence of the disassembling procedure.
8-3. FRONT MASK Disassemble/Assemble Method
8-3-1. Assembling/Disassembling with STAND attached.
(1)Detach BACK COVER (refer to FIG<19>)
(2)With BACK COVER detached, screw STAND holding screws. (Refer to FIG<6>)
(3)Unscrew the lower 2 screws of 3 screws located at the TERMINAL PLATE.
(Refer to FIG<19>)
(4)Detach KEY PCB
(5)Detach AC SWITCH & LED PCB
(6)Unscrew 4 FRONT MASK holding screws located at each corner of PANEL BACK PLATE
(Refer to FIG<7> ~ FIG<10>, FIG<13>)
(Note.1) At least two people must work together when assembling/disassembling FRONT
MASK.
(Note.2) Unscrewing these 4 screws separate FRONT MASK and PANEL completely.
Therefore, one person must be holding the FRONT MASK while unscrewing.
(7)Carefully separate FRONT MASK to the perpendicular direction from PANEL BACK PLATE.
Plastic guides located at the upper corners (left and right) of FRONT MASK is used for proper
connection to PANEL BACK PLATE.
(Refer to FIG<7> ~ FIG<10>, FIG<13>)
(8)Assembling procedure is in the reversing sequence of disassembling procedure.