Parts of the remote
controller
24
18. P.POSITION(Green) : Move the sub window position in
PIP mode. Position :
left bottom => left top => right top => right bottom
19. P.SWAP(Yellow) : Swap the main screen for sub screen.
20. P.INPUT(Blue) : Sub Screen input mode change as
follows PIP table mode or POP table mode.
21. + VOL - : Adjust the volume.
22.
W
PR
V
: Change programmes on TV mode.
23. MUTE : Press this button, and the sound goes off.
Press again, and the sound returns.
24. Multimedia Player Key : See the page 52.
25. Multimedia Player Key : See the page 52.
26. STILL : Press this button to freeze the picture.
27. ASPECT : Select screen aspect ratio :
Wide[16:9] => Zoom => Normal[4:3] =>Wide[16:9]
Note : When current mode is multimedia(PC, HDMI),
the aspect only work as the 16:9 mode
28. PICTURE : Picture modes change as follows :
Normal => Soft => Move => User => Sharp => Normal
29. SLEEP : Sleep Timer setting.
OFF => 30min => 60min => 90min => 120min => OFF
Note : If an active signal is not present for about 30 minutes,
the set will automatically turn to ST-BY mode.
17~20. Teletext : See the page 59.
25~29. Teletext : See the page 59.
Inserting Batteries into the Remote Control Unit
To load the batteries, turn the remote control handset over
and open the battery compartment. Insert the batteries (Two
1.5v, type AA).
Make sure that the polarity matches with the (+) and (-)
marks inside of the battery compartment.
Note
: To avoid damage from possible battery leakage,
remove the batteries if you do not plan to use the
remote control handset for an extended period of time.
1
7
8
11
13
15
17
21
24
25
26
23
18
4
3
2
9
10
12
14
16
20
22
29
19
27
28
5
6
