Daewoo DLP-2612, Руководство по обслуживанию

Страница: 27 / 77

-27-
5-2. Entering SERVICE MODE
There is two ways to enter Service Mode.
First, you make use of the SERVICE REMOCON, you can enter Service Mode directly.
Second, to enter SERVICE MODE with User Remocon,
Adjust Sharpness
“
0
”
in Picture mode =>Adjust PR
“
99
”
=> Press the
“
Red
”
,
“
Green
”
and
“
Blue
”
Button => Press the
“
menu
”
button.
In Service Mode, each number of User Remote controller correspond with each number of
Service Remote controller.
5-2-1. Adjustment REMOCON and EEPROM initial DATA
A. The adjustment Specification use the SERVICE REMOCON R-34SVC
(S/N: 48B3034SVC) or USER REMOCON R-50K18 (S/N: 48B5550K18)
B. Adjustment DATA
KEY Name Details
Function
remark
DEFAULT ADJUSTMENT
S1 Heat-Run - - It can check ROM VERSION.
S2 I2C STOP - -
S3
Sound/TIMER Test - VOLUME MIN CEN MAX
RIGH LEFT, TIMER ON OFF
S4
Tilt Test - BRIGHT MIN CEN MAX, CONTRAST MIN CEN MAX,
COLOUR MIN CEN MAX
S5 is ON KUMI, DEMPOL (is selected VOL KEY)
S5 EEPROM ERASE - press menu key, then eeprom data is erased
(excepting factory frequency)
- DECODER SET MAIN/SUB Adjustment.
- DEFAULT ADJUSTMENT
MAIN BRIGHT 136 NOT FIX
S6 DECODER
MAIN CONTRAST 132 NOT FIX
MAIN COLOR 115 NOT FIX
SUB BRIGHT 24 NOT FIX
SUB CONTRAST 88 NOT FIX
SUB COLOR 120 NOT FIX
OPERATING S7 ON WHITE PATTERN CH UP/DOWN
S7 PANEL TEST METHCO RED PATTERN CH UP/DOWN BLUE PATTERN
GREEN PATTERN S7 EXIT
HIGH BEAM PATTERN (It is generated SCALER)
OPERATING WHITE BALANCE ADJUSTMENT MENU KEY
METHOO LOW BEAM PATTERN (It is generated SCALER)
WHITE BALANCE ADJUSTMENT
SB SAVE & EXIT
S8
PANEL WHITE - DEFAULT ADJUSTMENT
BALANCE R DRIVE 0 FIX
G DRIVE 0 FIX
B DRIVE 0 FIX
OFFSET R 0 FIX
OFFSET G 0 FIX
OFFSET B 0 FIX
OPERATING S9 COMPONENT1 COMPONENT SIGNAL ADJUSTMENT
METHOO (IF EEPROM ERASE(S5) IS ON, THIS SETTING IS ERASED
- DEFAULT ADJUSTMENT
COMPONENT CR DRIVE 0 FIX
S9 VIDEO Y DRIVE 39 FIX
ADJUSTMENT CB DRIVE 0 FIX
CR OFFSET 0 FIX
Y OFFSET 7 FIX
CB OFFSET 0 FIX