E-14
cleanIng
1. Always disconnect the appliance from the mains supply.
2. Do not use abrasives. Periodically clean with a sponge dampened in lukewarm water. A neutral pH detergent may be used.
Rinse and dry with a soft cloth.
3. Wipe the outside with a soft cloth dampened in water.
4. Periodically clean the front grille and the radiator at the back with a vacuum cleaner or a brush
prolonged dIsUse
1. Empty the refrigerator and freezer compartments.
2. Unplug the appliance from the mains.
3. Clean and dry both compartments.
4. Leave the doors open to prevent the formation of unpleasant odors.
aFter sales serVIce
Before contacting our After Sales Service Department:
1. Try to remedy the problem (please read section “trouble shooting guide”).
2. Restart the appliance to check whether the fault repeats. If the malfunction persists, switch off the appliance and try again after
an hour.
3. If the malfunction still persists, then contact our Customer Service, specifying:
- the nature of the problem,
- the appliance model number,
- your full address, telephone number and area code.
NOTE :
Door opening direction changes carried out by our Customer Service are not covered by the terms of guarantee.
troUBleshootIng gUIde
1. The appliance does not work. Check:
- power failure,
- properly inserted plug,
- (if applicable) connection of the two-pole circuit breaker,
- damage to the mains lead,
- correct setting of the temperature controls.
2. The temperature inside the compartments is not low enough, Check for:
- closure of the doors,
- installation near a heat source,
- correct setting of the refrigerator / freezer control knob,
- inhibited air circulation.
3. The refrigerator compartment temperature is too low. Check for:
- correct setting of the temperature controls.
4. The internal light does not work. Refer to point 1 and then:
- unplug the appliance from the mains.
- check the bulb and replace if necessary (max.25W)
- to change the lamp, first remove the window of the lamp by pulling upper part forward.
- take out the lamp and replace it for a new one.
- finally set again window lamp on its place.
AD241-2a(영)_DESUK.indd 14
2012-06-01 오후 2:40:01
