EN
5
Water inlet screen
The water inlet filter must be inspected regularly, so as to avoid blockage and restriction in the water
supply to the pump (Fig. 5).
Using detergent
Add detergent to the container. Set the Adjustable Spray Wand at low pressure position. Trigger gun
to spray detergent.
7. GUN SAFETY DEVICE
Whenever you use the high pressure washer, we suggest you grip the in the right position, with one
hand on the handle and the other on the lance, When you stop the machine it is necessary to use
the safety lock placed on the gun in order to avoid accidental.
8. CLEANING PIN INSTRUCTION
• Using included tip cleaner, or an unfolded paper clip, insert wire into the nozzle hole and move
back and forth until debris is dislodged.
• Remove additional debris by back-flushing water through the nozzle. To do this, place end of a
garden hose (with water running) to the end of nozzle for 30-60 seconds.
3. SAFETY REGULATIONS
WARNING:
Read all the instructions before using the machine.
WARNING:
Machines shall not be used by children. Children should be supervised to ensure that
they do not play with the machine. This machine is not intended for use by persons (including chil-
dren) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge
WARNING:
The electrical supply connection shall be made by a qualified person and comply with
IEC 60364-1. The electric supply to this machine should include either a residual current device that
will interrupt the supply if the leakage current to earth exceeds 30 mA for 30 ms or a device that will
prove the earth circuit.
WARNING:
The machine is intended to be used at a temperature above o degree. (Only for machine
with power cord of H05VV-F).
WARNING:
The operating method to be followed in the event of accident (e.g. contact with deter-
gents: rinse with an abundance of clean water) or breakdown to prevent unsafe situations.
WARNING:
This machine has been designed for use with the cleaning agent supplied or recommen-
ded by the manufacturer. The use of other cleaning agents or chemicals may adversely affect the
safety of the machine.
WARNING:
Recommend the operator to wear ear protectors.
WARNING:
Do not use the machine within range of persons unless they wear protective clothing.
WARNING:
Do not direct the jet against yourself or others in order to clean clothes or foot-wear.
WARNING:
Risk of explosion-Do not spray flammable liquids.
WARNING:
High pressure hoses, fittings and couplings are important for the safety of the machine.
Use only hosed, fittings and couplings recommended by the manufacturer. WARNING: To ensure
machine safety, use only original spare parts from the manufacturer or approved by the manufactu-
rer.
WARNING:
Water that has flown through backflow preventers is considered to the non-potable.
WARNING:
The machine shall be disconnected from its power source by removing the plug from
the socket-outlet during cleaning or maintenance and when replacing the machine to another func-
tion.
WARNING:
Observe a distance of at least 30cm when using the jet to clean painted surfaces to
avoid damaging paintwork.
WARNING:
Do not use the machine if a supply cord or important parts of the machine are damaged,
e.g. safety devices, high pressure hoses, trigger gun.
WARNING:
If an extension cord is used, the plug and socket must be of watertight construction.
WARNING:
Inadequate extension cords can be dangerous. If an extension cord is used, it shall be
suitable for outdoor use, and the connection has to be kept dry and off the ground. It is recommen-
ded that this is accomplished by means of a cord reel which keeps the socket at least 60mm above
the ground.
WARNING:
In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this
appliance must not be supplied through an external switching device, such as a timer, or connected
to a circuit that is regularly switched on and off by the utility.
The machine is not intended to be connected to the potable water mains.
WARNING:
To ensure the machine safety, please only use original spare parts
(including nozzle) from the manufacturer or approved by the manufacturer. Do not use
the machine before you changed them if they are damaged.
WARNING: Be care of the danger of the kickback force on the spray assembly when
opening the trigger gun and grasp the gun with hands firmly.
WARNING:
To reduce the risk of injury, close supervision is necessary when a machine is used near
children. High-pressure cleaner shall not be used by children or untrained person. WARNING: Know
how to stop the machine and bleed pressures quickly. Be thoroughly familiar with the controls.
WARNING:
Stay alert and watch what you are doing.
WARNING:
Do not operate the machine when fatigued or under the influence of alcohol or drugs.
WARNING:
Keep operating area clear of all persons.
WARNING:
Do not overreach or stand on unstable support. Keep good footing and balance at all
times.
WARNING:
Follow the maintenance instructions specified in the manual.
WARNING:
This machine must be grounded. If it has malfunction or breakdown, grounding provides
a path of least resistance for electric current to reduce the risk of electric shock. The plug must be
plugged into an appropriate outlet that is properly installed and grounded in accordance with all
local codes and ordinances. The rating voltage (V/Hz) of the machine has to be in compliance with
the local power supplying voltage.
WARNING:
Check with a qualified electrician or service personnel if you are in doubt as to whether
the outlet is properly grounded. Do not modify the plug provided with the machine. If it will not fit
the outlet, have a proper outlet installed by a qualified electrician. Do not use any type of adapter
with this machine.
WARNING:
Use only 3-wire extension cords that have 3-prong grounding-type plugs and 3-pole
cord connectors that accept the plug from the machine. Use only extension cords that are intended
for outdoor use and the socket must be of watertight construction. These extension cords are
identified by a marking "Acceptable for use with outdoor machines; store indoors while not in use."
Use only extension cords having an electrical rating not less than the rating of the machine. Do not
use damaged extension cords. Examine extension cord before using and replace if damaged.
Inadequate extension cords can be dangerous. Do not abuse extension cord and do not yank on
any cord to disconnect. Keep cord away from heat and sharp edges. Always disconnect the exten-
sion cord from the receptacle before disconnecting the machine from the extension cord.
WARNING:
To reduce the risk of electrocution, don’t start and run the machine in the rain or storm.
Keep all connections dry and off the ground. Do not touch plug with wet hands. It is strictly prohibi-
ted to let water leak into the machine.
WARNING:
When the machine is turned on, the interior pumps start and continue to run even if the
pressure wand trigger has not been depressed. Running the machine for more than 3 minutes
without depressing the pressure wand trigger could cause heat damage to the motor and pumps,
Please do not leave the machine running unattended or unused for more than 3 minutes.
WARNING:
When the machine is running, please maintain a constant water supply. Without water
circulation will damage the sealing rings of the machine.
WARNING:
It is necessary to turn on the spray lance within one or two minutes after the machine
has been started. Otherwise, the temperature of the circulating water within the machine will soon
rise to a critical point, which will cause damage to the sealing rings inside the machine. WARNING:
Don’t start and run the machine in a place excessively cold so as to prevent the machine from the
freezing current.
WARNING:
This machine has been designed for only using cleaning water, do not use corrosive
chemicals.
WARNING:
Use cleaning agent supplied or recommend by the manufacturer.
WARNING:
High-pressure jets can be dangerous if subject to misuse.
The jet must not be directed at persons, animals, live electrical equipment or the
machine itself. Pressure washers should not be pointed at tire walls, as it may be
possible to damage them.
WARNING:
Do not direct the jet against yourself or others in order to clean clothes or footwear.
WARNING:
Disconnect from the electrical power supply before carrying out user maintenance. If the
mains cable is damaged it must be replaced by the manufacturer, or its service agent or similarly
qualified person to avoid a hazard.
WARNING:
Do not use the machine if a supply cord or important parts are damaged, e.g. safety
devices, high pressure hoses, trigger gun.
WARNING:
Be aware of the recoil caused by the water jet when the machine is switched on.
WARNING:
When the machine is moving and installing, the machine must be in flat. When moving
the machine, pulling the handle to move it.
WARNING:
Connect to the water supply. The machines are not suitable for connection to portable
water mains. Connect the machine to the water supply. (It can be a water container). Make sure the
inlet water pressure keeps between 0.01MPa and 0.4MPa.The inlet pipe should at least 5 M long. Do
not use the pipe if the pipe is damaged. If you want connect this machine to portable water mains,
you must install a backflow preventer in the water pipe to prevent dirty water flow back to the drin-
king water system. The backflow preventer shall comply with EN 60335-2-79 ANNEX AA.
4. OPERATING INSTRUCTIONS
This unit is to be connected to a cold water source ONLY.
The motor of this pressure washer will NOT run. It will only operate when the trigger is squeezed.
• Connect the outlet hose to the washer and connect the spray gun to the outlet hose.
• Connect nozzle and nozzle extension.
• Check gauze filter is clear of any blockage.
• Connect the water supply hose.
• Check that the hose has no kinks in it.
• Turn on water and check for leaks.
• Depress trigger to allow air to be expelled though the pump and hoses, lock trigger.
1. OVERVIEW
1. Water inlet
2. ON/OFF switch
3. High pressure washer
4. Water outlet (backside)
5. Mobile adapter bracket with wheel
6. Adjustable Spray Wand
7. Gun
2. APPLICATION
The high pressure washer is a highly specialized multifunctional machine with exceptionally reliable
safety assurance, which may be used to wash and clean cars, bikes and other outdoor equipment
or garden patios, green houses etc.
Helpful Hints for Getting Started Automatic ON/OFF:
The motor on this pressure washer does not run continuously. It only runs when the trigger of the
spray gun is squeezed. After following the start up procedures in this manual, turn the pressure
washer ON and squeeze the trigger for activation. See “Operating Instruction” section in this manual
for further details.
Bleeding the gun
It is very important to bleed the gun before using the pressure washer. Squeeze the trigger to allow
any air that is trapped inside of the unit and hose to escape. Continue to squeeze trigger until a
steady stream of water comes from the nozzle. (This process may take up to 2 minutes). See “Ope-
rating Instructions” section for this process.
• Plug in machine and turn on switch.
• Unlock trigger and use the pressure washer.
5. SHUT DOWN
1. Turn off the motor(push switch to the off position).
2. Unplug the unit from the power source.
3. Turn off the water supply.
4. Press the trigger of the gun to depressurize the system.
5. Disconnect the garden hose from the pressure washer.
6. Wipe all surfaces of the unit with a damp clean cloth.
7. Engage the gun safety lock.
CAUTION:
ALWAYS turn off the unit’s motor BEFORE turning off the unit’s water supply. Serious
damage could occur to the motor if the unit is run without water.
CAUTION:
NEVER disconnect the high-pressure discharge hose from the machine while the system
is still pressurized. To depressurize the unit, turn off the motor, turn off the water supply and
squeeze the trigger 2-3 times.
6. ADJUSTABLE SPRAY NOZZLE
Turn off the spray lance first, hold the rear part of spray nozzle, then turn the front part of spray
nozzle clockwise, Water may be sprayed out from the spray nozzle in fan shapes (Fig. 2); Turn the
front part of spray nozzle anti-clockwise, water may be sprayed out from the spray nozzle linearly
(Fig. 1).
CAUTION:
Water should be sprayed out from the spray nozzle in fan shapes (Fig. 2), when cleaning
the car or other vehicle.
Low/High pressure adjustable lance
Using high pressure:
Please make sure the trigger released and there is not any water spraying. then turn the rear part of
spray nozzle wither shins (Fig. 4). Squeeze the trigger, the gun will spray water with high pressure.
Using low pressure
Please make sure the trigger released and there is not any water spraying. then turn the rear part of
spray nozzle clockwise (Fig. 3). Squeeze the trigger, the gun will spray water with low pressure.
CAUTION: Selection of high or low pressure by turning action. The selection of the pressure must be
carried out with the gun in closed position.
