Daewoo International DWS-62, Руководство пользователя

Страница: 10 / 29

ENG
10
J. Indoor maximum/minimum indicator
Indicates the maximum/minimum indoor temperature and humidity are displayed.
K. Clock window
Display current time, current time and weekday, calendar or alarm time.
L. Radio reception signal
Indicates the condition of DCF77 radio controlled time reception.
M. Alarm on icon
Appears when alarm is activated.
DESCRIPTION OF BUTTONS
DWS-62 has 6 major function buttons on top and both edges.
1. [SNOOZE/LIGHT]
Press once to activate the LCD backlight for 5 seconds or snooze function.
2. [

/Unit]
Press once to decrease the setting in CLOCK, CALENDAR or ALARM setting mode.
While in clock display mode, press once to toggle between C0 and F0.
3. [

/CH]
Select among channel 1, 2, 3 or to enter auto scroll mode.
Press and hold 2 seconds to activate or deactivate the sensor searching mode.
4. [Max/Min]
Toggle to view the Max/Min reading of the Indoor & Remote Temperature/Humidity.
Press & hold 2 seconds to clear Indoor & current channel Remote temperature/humidity
memories.
5. [ ]
While in alarm display mode, press once to toggle between enable or disable the daily alarm.
Press & hold 3 seconds to manually activate the radio controlled function and press once for
deactive.
6. [MODE/Enter]
Toggle amongst display for Clock-Sec (HR-MIN-Sec), Clock-day (HR-MIN-Weekday), Alarm 1, Alarm
2, Calendar (Date-Month-Weekday) and repeat…
Press & hold 2 seconds to access setting mode of clock and alarm.
GETTING STARTED
This Weather Station was designed for easy set up. For best operation, the following steps are
required to be done in the proper sequence.
1. Insert batteries for main unit before doing so for the sensor units.
2. Receiving unit cannot be programmed manually until the wirelss remote sensor unit registration
procedure has been completed.
3. Position the remote unit and main unit within eff ective transmission range, which, in usual
circumstance, is 250 feet.
Although the remote unit is weather resistant, it should be placed away from direct sunlight, rain
or snow.
BATTERY INSTALLATION FOR MAIN UNIT
1. Remove the battery door.
2. Insert 3 pieces of AA size 1.5V alkaline battery as indicate by the polarity.
3. Close the battery door.
Note: Replace the batteries when the low battery indicator appears on the bottom-left corner
of the LCD.
BATTERY INSTALLATION FOR REMOTE SENSOR UNIT
1. Remove the battery cover by grabbing its bottom edge (near the two recess location) from
bottom of sensor unit.
2. Insert 2 pieces of AA size batteries according to the “+” and “-” polarity marks shown in the battery
compartment and then close the battery door with the clip on (press down the snap on both sides
slightly).