6
This appliance must be earthed. In the event of an electrical short circuit,
earthing reduces the risk of electric shock by providing an escape wire
for the electric current. This appliance is equipped with a cord having a
earthing wire with an earthing plug. The plug must be plugged into an
outlet that is properly installed and earthed.
INSTALLATION
EARTHING INSTRUCTIONS
WARNING :
Improper use of the earthing plug can result in a risk
of electric shock. Consult a qualified electrician or serviceman if the
earthing instructions are not completely understood, or if doubt exists as
to whether the appliance is properly earthed. If it is necessary to use an
extension cord, use only a 3-wire extension cord that has a 3-blade
earthing plug, and a 3-slot receptacle that will accept the plug on the
appliance. The marked rating of the extension cord should be equal to or
greater than the electrical rating of the appliance.
3. Leave space behind and side
All air vents should be kept a clearance. If all vents are covered during operation,
the oven may overheat and, eventually, oven failure.
4. Away from radio and TV sets
Poor television reception and radio interference may result if the oven is located
close to a TV, Radio antenna, feeder and so on. Position the oven as far from them
as possible.
5. Away from heating appliance and water taps
Keep the oven away from hot air, steam or Splash when choosing a place to
position it, or the insulation might be adversely affected and breakdowns occur.
6. Power supply
• Check your local power source. This oven requires a current of approximately 10
amperes, 2
3
0V 50Hz.
• Power supply cord is about 1.0 meters long.
• The voltage used must be the same as specified on this oven. Using a higher
voltage may result in a fire or other accident causing oven damage. Using low
voltage will cause slow cooking. We are not responsible for damage resulting
from use of this oven with a voltage of ampere fuse other than those specified.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or a similarly qualified persons in order to avoid a hazard.
7. Examine the oven after unpacking for any damage such as:
A misaligned door, Broken door, A dent in cavity. If any of the above is visible,
DO NOT INSTALL, and notify dealer immediately.
8. Do not operate the oven if it is colder than room temperature.
(This may occur during delivery in cold weather.) Allow the oven to become room
temperature before operating.
9. PRIOR TO USE
The grill element is covered with protective coating on its surface in order to protect
it from getting damaged in transit.
At the time of using the oven with grill feature at first, this coating may be burnt and
give rise to an unpleasant odour and some smoke.
Therefore, we recommend boiling 200cc of water with grill feature for 10 minutes in
order to burn this coating off in advance before using the oven normally.
1. Ventilation
Do not block air vents. If they are blocked during operation, the oven may
overheat and eventually cause a failure. For proper ventilation, allow
above 100mm of space between oven sides, rear and the minimum
height of free space necessary above the top surface of the oven is
200mm.
2. Steady, flat location
This oven should be set on a steady, flat surface. This oven is designed
for counter top use only.
The microwave oven shall not be placed in a cabinet unless it has been
tested in a cabinet.
2017-10-19 오후 2:37:24
