DAELIM S2-125, Руководство по обслуживанию

Страница: 65 / 222

5-17
EMS(Engine Management System)
8.TPS(THROTTLE POSITION SENSOR)
Remove
Lh.side cover
Air cleaner
TPS connector
TPS screw
Replace the TPS
It is Located on the right side of throttle body
Before disassembly, the key is off.
!
CAUTION
Checking of intake temperature sensor
4) Turn on the ignition key. Start the engine and idling.
5) Measure the voltage of intake pressure sensor for ECU check.
Measuring the voltage of intake pressure sensor
- Measuring terminal: ECU No.28(TBA)
~ ECU No.3(IMP GROUND)
- Measuring voltage: 0.1[V] ~ 4.9[V]
Remarks : Measuring unit of voltage : Voltage [V]
6) If the measured voltage is not normal,
Check the ‘P’ electric wire, ‘P/G’ electric wire, ‘P /L’ electric wire to see if they have been broken
or have short- circuited.
Replace the MAPAT sensor with new one and it rechecks.
If the measured voltage is normal,
Check the ‘P’ electric wire, ‘P/G’ electric wire, ‘P/L’ electric wire to see if they have been broken or have
short- circuited if there is a bad contact of terminal No. 3, No. 26, No.28 of ECU coupler.
If the electric wire is no problem, ECU is broken.
Replace ECU with the new one, it rechecks.
7) After fault repaired, To erase the memorized fault code in the ECU is refer to how to remove the fault code(5-10).