DAELIM B-BONE, Руководство по обслуживанию

Страница: 147 / 246

VALVE GUIDES
INSPECTION
●
Insert the valve guide reamer from the combustion
chamber side and ream the guide to remove any carbon
build-up before measuring the guide.
TOOL : VALVE GUIDE REAMER
● Measure and record each valve guide inner diameter.
SERVICE LIMIT : 5.030 mm
●
Measure the guide-to-stem clearance with a dial
indicator while rocking the stem in the direction of
normal thrust.
SERVICE LIMIT : IN : 0.090 mm
EX: 0.120 mm
●
Measure the inner diameter of the new valve guide. If
the clearance is not within the service limit, replace the
valve.
REPLACEMENT
●
Heat the cylinder head to 130
°
C - 140
°
C (275
°
F - 290
°
F).
●
Support the cylinder head and drive the old guides out
of the combustion chamber side of the cylinder head.
TOOL : VALVE GUIDE DRIVER
10-7
CYLINDER HEAD / VALVES
VALVE GUIDE REAMER
VALVE GUIDE REAMER VALVE GUIDE REAMER VALVE GUIDE REAMER
VALVE GUIDE REAMER VALVE GUIDE REAMER
VALVE GUIDE REAMER VALVE GUIDE REAMER VALVE GUIDE REAMER
VALVE GUIDE REAMER VALVE GUIDE REAMER VALVE GUIDE REAMER
VALVE GUIDE REAMER VALVE GUIDE REAMER VALVE GUIDE REAMER
VALVE GUIDE REAMER VALVE GUIDE REAMER
VALVE GUIDE REAMER VALVE GUIDE REAMER VALVE GUIDE REAMER VALVE GUIDE REAMER
VALVE GUIDE REAMER
VALVE GUIDE
VALVE GUIDE VALVE GUIDE
VALVE GUIDE VALVE GUIDE VALVE GUIDE
VALVE GUIDE VALVE GUIDE
VALVE GUIDE VALVE GUIDE VALVE GUIDE VALVE GUIDE VALVE GUIDE
VALVE GUIDE VALVE GUIDE
VALVE GUIDE VALVE GUIDE VALVE GUIDE
VALVE GUIDE VALVE GUIDE VALVE GUIDE
VALVE GUIDE
VALVE GUIDE DRIVER
VALVE GUIDE DRIVER VALVE GUIDE DRIVER VALVE GUIDE DRIVER
VALVE GUIDE DRIVER VALVE GUIDE DRIVER VALVE GUIDE DRIVER
VALVE GUIDE DRIVER VALVE GUIDE DRIVER VALVE GUIDE DRIVER VALVE GUIDE DRIVER VALVE GUIDE DRIVER VALVE GUIDE DRIVER VALVE GUIDE DRIVER
VALVE GUIDE DRIVER VALVE GUIDE DRIVER VALVE GUIDE DRIVER
VALVE GUIDE DRIVER VALVE GUIDE DRIVER VALVE GUIDE DRIVER VALVE GUIDE DRIVER
VALVE GUIDE DRIVER
●
Take care not to tilt or lean the reamer in the guide
while reaming.
●
Rotate the reamer clockwise, never counterclockwise
when inserting and removing.
!
NOTE
△
●
Avoid damaging the head when driving the valve
giude out.
!
NOTE
△
●
Do not heat the cylinder head beyond 150
°
C (300
°
F).
●
Use temperature indicator sticks, available from
welding supply stores, to be sure the cylinder head is
heated to the proper temperature.
●
Using a torch to heat the cylinder head may cause
warping.
●
Wear insulated gloves to avoid burns when handling
the heated cylinder head.
●
Refinish the valve seats whenever the valve guides are
replaced to prevent uneven seating.
!
CAUTION
△