5
-25
OPERATION
5
2. The draft function is activated when
the lowest or middle hole on the top
link of the 3-point hitch is used. The
lowest hole is for sensitive draft
control.
3. To keep the plowing depth shallow,
put the draft control lever to the rear
(shallow) position.
The plowing depth tends to become
deeper naturally by outer
conditions.
When the load increases by the in7.
H11O581A
(1) Top Link
crease of the plowing depth while the
draft control lever is set to the “Shal-
low” position, the plowing depth is
maintained as shallow because the
reaction force is transferred to the
internal system via the top link and
the lifting arm is automatically lifted.
4. To keep the plowing depth deep, put
the draft control lever to the front
(deep) position.
5. The position of the draft control le-
ver should be different based on the
condition of soil to keep the plow-
ing depth constant.
When working on a new field, it is
recommended to put the draft con-
trol lever to the proper position for
the desired plowing depth and lock
the lever with the lock bolt.
6. When using an implement which
requires no draft function, such as
a rotary tiller and mower, use the
highest hole on the top link and put
the draft control lever in any
position.
If the lifting arm is properly op-
erated but abnormal noise is
still heard, the hydraulic system
may be malfunctioning. In this
case, le the engine idle for an
additional 10 to 15 minutes and
then try to start the engine
again. If the problem is still
present, contact your local
KIOTI Dealer.
!!!!!
CAUTION
7. However, if the draft control lever is
pushed forward to its end, the low-
est position of the lifting arm can be
lowered a little. On the other hand,
if the lever is pulled back to its end,
the highest position of the lifting arm
can be raised a little.
Содержание KIOTI DK35SE
