Dacor Renaissance Series MRES30S, Руководство по установке

Страница: 5 / 16

3
Product Specifications
Electrical Requirements
• It is the owner’s responsibility to ensure that a licensed
electrician performs the installation of the electrical supply for
this appliance. The electrical installation, including minimum
supply wire size, must comply with the National Electric
Code ANSI/NFPA 70 (latest revision) and local codes and
ordinances.
A copy of this standard may be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, Massachusetts 02269-9101
• The correct voltage, frequency and amperage must be
supplied to the appliance from a dedicated, grounded, single
phase circuit that is protected by a properly sized circuit
breaker or time-delay fuse. If a time-delay fuse is utilized,
fuse both sides of the line (L1 and L2).
35”
(88.9 cm)
5/16”
(8 mm)
11/16” - 1 13/16”
(1.7 cm - 4.6 cm)
Removable (factory installed)
3” (7.6 cm) side panels
Optional full size side panels
(ARSL30S, ARSR30S)
56” (142 cm) long
240 Vac 4 wire
conduit location
Door opened
Range top
23 1/2”
(59.7 cm)
25 5/16”
(64.3 cm) Rear of control
Panel/oven door
Max. depth
to front of
control panel
with door closed
29 15/16”
(76.0 cm)
45 5/16”
(115.1 cm)
Product tolerances: ±1/16” (±1.6 mm), unless otherwise stated
Product Dimensions
Dimensions - Top View
Dimensions - Isometric View
WARNING
If the electric service provided does not meet the product
specifications, do not proceed with the installation. Call the
selling dealer or a licensed electrician.
Electrical Specifications
Dedicated Circuit
Requirements
Total Connected Load
240 Vac 60 Hz,
4 wire*, 50 Amp.
10.3kW (48.2 Amp.)
* Two 120 Vac hot (L1 and L2), one neutral (N1) and one ground.
The above electrical specifications are for reference only. See
the range data plate for exact specifications. See inside cover for
location.
NOTE: If the appliance is connected to a 208 volt power supply,
preheat times and cavity temperature recovery times will be
increased slightly.