Dacor Renaissance RNTT365GB, Инструкция по использованию и уходу

Страница: 10 / 24

8
Using the Auto-Shutoff Timer
The auto-shutoff timer allows you to program a
timer that automatically shuts off a burner before
the default 4-hour shut-off time.
Afterward, the burner will reset to the default
4-hour time limit. However, if the burner is turned
OFF before the timer ends, the timer is canceled.
To Set the Auto-Shutoff Timer:
Refer to the above diagram while following these
instructions.
1. Make sure the cooktop is on (the
burner displays are lit). If necessary,
touch the ON/OFF button for about
two seconds to power on.
2. Choose the burner(s) you want to
time. Light the burner(s) and adjust
the flame.
3. Touch the clock button repeatedly until the
burner that you want is indicated on the
burner location indicator. Only burners that are
lit will be displayed.
• The timer display will show “t 0.00 ”
(hours . minutes).
• Touch the clock “—” and “+” buttons
repeatedly to set the timer. TIP : if you touch
the clock “—” button first, the display will
start at 3.59 and count DOWN. If you touch
the clock “+” button first, the display will
start at 0.01 and count UP.
• When you stop at your desired time, the
display will flash after a few seconds, then
timing will begin.
• When the time ends, the burner will
automatically shut off and the alarm will BEEP
for 30 seconds.
• Touch the clock button to stop the beeping.
4. Touch the clock button repeatedly to select
which burners to set. Repeat the above steps.
To Toggle Between Options : Touch the clock
button to cycle through choices. The selected
burner will flash on the burner location indicator,
and the time will show on the timer display. The
timer settings for that burner can be modified by
pressing the clock “—” and “+” buttons.
Operating Your Cooktop
To Cancel the Timer on a Burner: Touch the
clock button until that burner is identified on the
burner location indicator. Touch clock “—” and
“+” buttons at the same time . The burner will
stay lit, but default (4 hour shut-off) will resume.
Cooking Tips
For superior cooking performance and to
save energy:
• Reduce flame to the minimum level neces-
sary to cook. Food cooks just as quickly from
a gentle boil as it does from a vigorous, roll-
ing boil. A higher boil than necessary wastes
energy, pulls out moisture, damages food, and
causes loss in flavor and nutrients.
• Use low or medium flame when using cook-
ware that are poor conductors of heat, such
as glass, ceramic, and cast iron. Reduce the
flame height until it spreads approximately 1/3
underneath the bottom of the pan to ensure
even heating and to reduce scorching.
• Using timers instead of repeatedly removing
the lid to check food is a more efficient way of
cooking. Doing so will decrease cooking time,
save energy, and keep a consistent cooking
temperature.
Using the Wok Ring
WARNING
• Use the Wok ring on the SEAR burner ONLY.
• Ensure the Wok ring is secure on the grate.
• Make sure the burner is cool when placing or
removing the Wok ring, or use a potholder.
1. Put the Wok ring on the center of the sear burner
grate as shown below.
2. Line up the fingers on the Wok ring with the fingers
on the grate.
Timer display
WoK ring
Sear grate
burner
(right rear burner selected)
Clock button
“—”
button
“+”
button
Burner location indicator
Wok Ring + Sear Grate Placement
ON / OFF
Button
Timer Controls