Dacor Millennia EDW24, Инструкция по использованию и уходу

Страница: 14 / 28

12
The Rinse Aid Dispenser
rinse aid is important to the drying process of the dish ware. its
sheeting action also reduces spotting. Dacor recommends that
you keep the rinse aid dispenser full and properly adjusted (see
below) at all times.
a rinse aid containing citric acid may be used to remove the
white or gray film caused by very hard water.
the rinse aid indicator on the dispenser turns dark
when full and clear when it is time to refill. Also,
the display will read lo at the end of the dish
washing cycle when it is time to refill.
To refill the rinse aid dispenser:
turn the rinse aid cap counterclockwise 1/4 turn and lift it 1.
out.
Slowly pour the rinse aid into the filler hole until the indica - 2.
tor turns dark. Do not overfill.
wipe up any spillage with a damp rag. 3.
replace the rinse aid cap and turn it clockwise to the closed 4.
position.
adjusting the rinse aid Dispenser
the rinse aid dispenser must be properly adjusted. too little
rinse aid will allow spotting and drying problems. too much rinse
aid will cause foaming and streaking.
the rinse aid setting is located under the rinse aid cap.
to change the setting:
remove the rinse aid cap. 1.
if you have spotty or improperly dried dishes, move the 2.
rinse aid setting a little higher. if you have streaks on your
dishes, move the rinse aid setting a little lower. the harder
the water, the more rinse aid required for acceptable results.
replace the cap.
3.
check the dishes after the next wash load. continue adjust- 4.
ing the rinse aid dispenser up or down according to the
guidelines above until you have spot free, streak free, dry
dishes.
if you have very soft water and still experience streaking when
the dispenser is set to 1, you can dilute the rinse aid with water
before pouring it into the dispenser to get acceptable results.
Loading Your Dishwasher
rinse aid cap
pour rinse aid in hole
rinse aid level adjustment