Dacor ELECTRONICS, Руководство пользователя

Страница: 11 / 40

Elecronic Diagnostics Page 11
F-7, F-8
Door Failure Codes
For Single Wall Ovens and Ranges
Phase Switch NC
Lock Switch NC
If the oven is in the Self Clean cycle, and after a short period of time the latch locks and the Self Clean display
reverts back to the time of day, check the latch switches on the latch assembly for an open latch switch or an
open wire coming off of the latch switches to the back of the erc control. You should also check to be sure
that the latch is wired correctly
.
If oven is programmed into a Self Clean cycle and you get the word DOORin the clock display:
1) Check for DC voltage out of the back of the ERC control at the 8 pin connector at J4. There are 5 colored
wires in the 8 pin connector - they are (1-yellow, 1-orange, 1-brown, 2-white.) Check for power at the
brown wire - there should be 22-24 volts dc. If no voltage is present at the brown wire; check the wiring
to ground and the latch switches for a grounded wire or miswired switches.
2) Check voltage at J4 - the 8 pin connector coming of f the back of the ERC clock control should read
22-24 volts dc at all times.
This the voltage feeds the latch switches. If no voltage is present out of the
ERC (clock control), replace the ERC.
3) Check the alignment of the door latch with the outer/inner door liner when it locks. It may not allow the
door latch to lock properly and cause the door switches to activate properly
.
Latch Switch -