21
Complete Installation
Turn the water supply line valve to the “Open” position.
1.
Turn the refrigerator switch to the ON position. See
2.
Power On/
Off Switch
in the use and care manual for instructions. Wait a
few minutes. Check the water line connections for leaks.
Remove all boxes, parts packages and packing materials from
3.
the interior of the refrigerator. See the
Care and Cleaning
section in the use and care manual for instructions. Remove
the film and cardboard from the grille and doors or door frame,
depending on your model.
Install the shelves and bins in the refrigerator and freezer
4.
compartments.
The controls are preset at the factory to the midpoint setting.
5.
Check that the compressor is operating properly and that all
the lights are working.
Flush the water system before use. See
6.
Water System
Preparation
.
To get the most efficient use from your new built-in refrigerator,
read your use and care manual. Keep Installation Instructions and
the use and care manual near the refrigerator for easy reference.
Water System Preparation
Please read before using the water system.
Immediately after installation, follow the steps below to make sure
that the water system is properly cleaned.
Open the freezer door and turn off the ice maker.
1.
For non-dispenser models, lift up the ice maker cover, then, lift
up the wire shutoff arm as shown.
For dispenser models, move the switch to the
OFF
(right)
setting as shown. The On/Off switch is located on the top right
side of the freezer compartment.
Installation Instructions
NOTE
: If your model has a base grille filter system, make sure
the base grille filter is properly installed and the cap is in the
horizontal position.
Use a sturdy container to depress the water dispenser bar
2.
until the water begins to flow. Flush the water system by
dispensing and discarding 6 qt. (5.7 L) of water. Cleaning the
system will take approximately 3 to 4 minutes and will help
clear air from the line. Additional flushing may be required in
some households.
NOTE
: As air is cleared from the system, water may spurt out of
the dispenser.
Open the freezer door and turn on the ice maker. For non-
3.
dispenser models, lower the wire shutoff arm. For dispenser
models, move the switch to the ON (left) position.
Allow 24 hours to produce the first batch of ice.
Discard the first three batches of ice produced.
Depending on your model, you may want to select the
maximum ice feature to increase the production of ice.
Any questions or problems with this installation should be directed
to your Dacor dealer or the Dacor Customer Service Team at
(800) 793-0093 or visit our web site at www.Dacor.com.
If you need service, be sure to have the model and serial
numbers when you call. You’ll find these numbers on the serial
number plate, located on the right hand side of the fresh food
compartment.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Ice Maker
Dispenser Models
Non-Dispenser Models
Ice maker cover
