2
l
oCaTion
r
equiremenTs
Your Dacor refrigerator can be recessed in an opening between
cabinets or installed at the end of a cabinet run using a side panel
to enclose the refrigerator.
IMPORTANT:
•
Observe all governing codes and ordinances.
•
To ensure proper ventilation for your refrigerator, allow for
1/2” (1.3 cm) space on each side and at the top. Allow for a
1” (2.5 cm) space behind the refrigerator.
•
Do not install the refrigerator in a location where the
temperature will fall below 55°F (13°C).
•
Allow a minimum of 2 1/2” (6.4 cm) space between the side
of the refrigerator and an oven or range.
•
The floor must be able to support the refrigerator’s weight of
more than 600 lbs (272 kg), the door panels and the contents
of the refrigerator.
•
The area to the left and the right of the appliance must
permit both doors to open to a minimum of 90°. Allow space
between the side of the refrigerator doors and a corner wall
for the handle and/or custom door panels.
P
roDuCT
D
imensions
•
The depth from the front of the door (w/o door handles) to the
back of the refrigerator chassis is 27” (68.6 cm).
•
The depth of the cabinet less the door is 24 1/4” (61.6 cm).
•
The power cord is 60” (152.4 cm) long.
•
The height from the top of the refrigerator to the floor with the
leveling legs in the down position is 69 15/16”
(177.6 cm), 71 7/8” (182.6 cm) with the optional top trim kit
(Part # AFG36).
D
esign
s
PeCifiCaTions
i
nsTallaTion
s
PeCifiCaTions
T
ools
anD
P
arTs
Make sure that you have the necessary tools and materials
available for a proper installation:
•
Phillips screwdriver set
•
Slotted screwdriver set
•
1/4” (6 mm) copper tubing for the water line. Provide sufficient
length to allow for a minimum of a 24” (61.0 cm) diameter
service loop.
•
Compression nut and compression sleeve to connect to
the water supply valve. A compression nut and sleeve are
included with the refrigerator to connect the refrigerator side
of the line.
•
Copper tubing cutter
•
Level - 2’ (0.6 m) and 4’ (1.2 m) recommended
•
Appliance dolly able to support 700 lbs (317 kg) and
adequate manpower to handle the weight of the appliance
•
Nut driver set or socket set
•
Crescent wrench
•
Cordless drill and assorted drill bits
•
Plywood or cardboard to protect finished flooring
•
Appropriate materials to cover and protect the home and its
furnishings during installation
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fire.
•
The height from the top of the refrigerator to the floor with the
leveling legs in the fully extended position is 70 9/16”
(179.2 cm) at the front of the unit, 72 1/2” (184.2 cm) with the
optional top trim kit (Part # AFG36).
•
The refrigerator width from edge to edge is 35 5/8” (90.5 cm).
