14
Complete Installation
1. Turn the water supply line valve to the “Open” position.
2. Turn the refrigerator switch to the ON position. See
Power On/
Off Switch
in the use and care manual for instructions. Wait a
few minutes. Check the water line connections for leaks.
3. Remove all boxes, parts packages and packing materials from
the interior of the refrigerator. See the
Care and Cleaning
section in the use and care manual for instructions. Remove
the film and cardboard from the grille and doors or door frame,
depending on your model.
4. Install the shelves and bins in the refrigerator and freezer
compartments.
5. The controls are preset at the factory to the midpoint setting.
Check that the compressor is operating properly and that all
the lights are working.
6. Flush the water system before use. See below.
Water System Preparation
Please read before using the water system.
IMPORTANT:
After connecting the refrigerator to a water source
or replacing the water filter, follow the steps below to make sure
that the water system is properly cleaned. This will flush air from
the filter and water dispensing system, and prepare the water filter
for use.
1. Open the freezer door and turn off the ice maker. Move the
switch to the
OFF
(right) setting as shown. The On/Off switch
is located on the top right side of the freezer compartment.
NOTE
: If your model has a base grille filter system, make sure
the base grille filter is properly installed and the cap is in the
horizontal position.
2. Use a sturdy container to depress and hold the water
dispenser lever for 5 seconds, then release it for 5 seconds.
Repeat until water begins to flow. Once water begins to flow,
continue depressing and releasing the dispenser lever (5
seconds on, 5 seconds off) until a total of 3 gal. (12L) has
been dispensed. Additional flushing may be required in some
households.
NOTE
: As air is cleared from the system, water may spurt out of
the dispenser.
Installation Instructions
3. Open the freezer door and turn on the ice maker by moving
the switch to the ON (left) position.
Allow 24 hours to produce the first batch of ice.
Discard the first three batches of ice produced.
Depending on your model, you may want to select the
maximum ice feature to increase the production of ice.
To get the most efficient use from your new built-in refrigerator,
read your use and care manual. Keep Installation Instructions and
the use and care manual near the refrigerator for easy reference.
Any questions or problems with this installation should be directed
to your Dacor dealer or the Dacor Customer Service Team at
(800) 793-0093 or visit our web site at www.dacor.com.
If you need service, be sure to have the model and serial
numbers when you call. You’ll find these numbers on the serial
number plate, located on the right hand side of the fresh food
compartment.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Ice Maker
Dispenser Models
