48 English
Maint
enanc
e
Maintenance
Ladder racks
The Ladder Racks can be removed for manual cleaning or to prevent discoloration
during a Self-Cleaning cycle.
Removing the Ladder racks
1.
Grasp the Position 2 rack guide, and
then lift the Ladder Rack straight up.
This frees the Ladder Rack from the
two supports on the oven wall.
2.
Rotate the Ladder Rack by
approximately 45°.
3.
Pull the Rack away from the oven wall
to remove it from the two support
holes in the wall of the oven.
4.
Repeat this procedure with the Ladder
Rack on the opposite wall.
To apply the graphite lubricant
1.
Shake the graphite lubricant before
opening it.
2.
Apply 4 drops of lubricant to the inner
side of the left sliding track and 4 drops
to the outer side of the left sliding
track.
3.
Repeat Step 2 above on the right
sliding track.
4.
Extend and collapse the gliding rack
several times to distribute the lubricant.
NOTE
•
Do not use a dishwasher to clean the racks.
•
If a rack does not slide in and out smoothly, apply a few drops of cooking oil
to the oven rack guides.
•
If a rack becomes too difficult to slide in or out, lubricate the rack.
•
To purchase the graphite lubricant, contact us at 833-35-ELITE
(833-353-5483).
CAUTION
•
Do not leave racks in the oven during the self-cleaning cycle. The extreme
heat generated in this cycle can permanently peel off the racks' coating and
make it difficult to remove the racks.
•
Do not spray cooking oil or lubricant directly onto the gliding rack.
DOP36P86DLS_DA_DG68-01105E-00_EN+MES+CFR.indb 48
2020-07-06 오후 3:53:55
