Dacor Distinctive DTCT304G, Руководство по установке

Страница: 12 / 20

10
Tabs
5 places
Notches
5 places
Installation Instructions
Installing the Burner Assemblies
WARNING
• Never attempt to operate the cooktop with any of the
burner parts removed.
• Do not attempt to adjust the burner air mixture set-
tings. All adjustments are preset at the factory.
1. Remove the burner heads, burner rings, burner caps,
and grates from their shipping packages.
2. Install the burners as shown. When installing the burn-
er components, twist each piece back and forth slightly
until it drops completely into place. The burners will
not operate properly unless all of the burner pieces are
properly seated.
3. Gently set the grates on top of the spill tray. Make sure
that the rubber feet are seated in the grooves.
Burner Ring Installation Detail
Cooktop Burner Components
Verifying the Correct Setup
WARNING
• Make sure that power to the electrical outlet is turned
off at the circuit breaker panel or fuse box and that
the gas is turned off at the gas supply valve before
proceeding.
• The cooktop must be properly grounded at all times
when electrical power is applied.
Prior to operating the cooktop, carefully read the
accompanying Use and Care Manual.
1. Make sure all the cooktop burner controls are in the
OFF position.
2. Connect the power cord to an electrical outlet.
3. Flip the power on at the electrical outlet, the circuit
breaker, or fuse box.
4. Press down and turn one burner control knob slowly
(left) to the HIGH flame mark. Verify that the correct
burner igniter sparks.
5. Return the control knob to the OFF position.
6. Repeat for all of the remaining control knobs.
7. Turn on the gas supply valve.
8. Perform the following
IGNITION TEST for all burners:
Refer to the diagram below:
• Press and turn the control knob slowly left to the HIGH
flame mark. It may take up to four seconds for the
burner to ignite. Once the burner is lit, the igniter will no
longer spark.
If ignition does not occur within four seconds,
• Turn off the knob, wait for at least five minutes to allow
any gas to dissipate, then repeat the test.
OFF
Knob
Selector
High
Flame
Control
Low
Flame
Flame
Burner
indicator
Burner Control Knob
Grate
Burner cap
Burner ring
base Burner
tray Spill
(attached)
(attached)
Feet
Grooves