Dacor DDW24S, Инструкция по использованию и уходу

Страница: 18 / 24

16
Before You Call for Service
Error messages
Below is a list of the possible error messages that may appear on the display in some cases and the suggested
action.
Error Message May Be Caused By What to Do
F:10 Overfilling Call Dacor Customer Service.
F:11 Water outlet fault See “Water left in bottom of dishwasher” below.
F:12 Water inlet fault Make sure water supply valve is on.
F:40 Inlet valve leakage Turn off the water supply valve and call Dacor
Customer Service.
Problem Solution Guide
Before you call for service, please review the Problem Solution Guide below.
Problem May Be Caused By What to Do
Dishwasher will not start
(control panel is not lit)
Main power switch is off Open door and turn on main power switch on top
of door before selecting cycle. See page 10.
Power is disconnected Make sure power is on at the circuit breaker panel
and that the power plug is properly connected to
electrical outlet (if applicable).
Blown fuse or tripped circuit
breaker
Replace fuse or reset circuit breaker. Remove
other appliances from circuit.
Power failure Contact electric company.
Dishwasher will not start
(control panel is lit)
Door not completely closed
(horizontal lines appear on
display)
Gently push in on front of door until you hear a
click.
Controls not set Make sure dishwasher controls are properly set
and door is closed. See page 10.
Child lock activated See page 3 to bypass. See page 12 to
deactivate.
Control panel keys dirty Clean keys with soft, slightly damp cloth.
No water supply Make sure water valve is turned on.
Water supply line blocked Make sure water supply line to dishwasher is not
kinked.
Drain pump clogged (loud
buzzing sound)
Disconnect power and clean entire filter system
and drain pump. See page 13. Reconnect power
and attempt to restart. If problem persists, shut off
the water supply, disconnect power and call for
service.
Water left in bottom of
dishwasher near filters,
dishwasher will not
drain
Dishwashing cycle not
complete
Allow dishwasher to complete cycle.
Obstruction in the drain hose
or air gap is plugged
Check for kinked drain hose. Disconnect end of
drain hose. Check for debris in hose or any other
part of drain/plumbing system. NOTE: The cone-
shaped part of the hose must be at least 1/2”
(1.3 cm).
Filter system clogged Clean entire filter system. See page 13.
Debris in the drain pump Clean the drain pump/filter system. See page 13.