• Put the two cabinet guide assemblies, and shims if
necessary, as shown, on the inside surfaces of the
cabinet. Position them flush with the front edge of
the cutout opening.
• Insert the screws in the holes of the guides without
tightening them completely.
• Make sure the outside distance between the fixing
angles is 22 1/8” (562mm) and that the guides are
level. Change the number of shims or adjust the
fixing angles as necessary.
IMPORTANT: Make sure that guides are level.
• Tighten all of the screws.
• Make sure that the power cord and water feed line
can be fed freely through the back wall.
• In order to avoid overheating the coffee system,
make an opening of at least 3 15/16” (100mm) at the
back of the cabinet to allow air to circulate.
The cabinet guides mount to the inside of the cabinet.
The glides on the coffee system slide into the cabinet
guides. The guide system allows the coffee system to
slide in and out of the cabinet for loading the coffee
bins and for maintenance.
To install the cabinet guides:
• Determine the number of shims required to mount the
cabinet guide assemblies according to the chart and
diagrams below. The appliance is supplied with six
1/16” (1mm) metal shims. Use the shims to position
the fixing angles so that they are properly spaced.
The appliance will not slide in and out of the cabinet
properly if the fixing angles are not properly spaced.
I
nsTallaTIon
I
nsTruCTIons
22 1/8” (562mm) Min.
3/4” (19mm)
Min. Side Walls
3 15/16” (100mm)
Cabinet Back Cutout for
Air Circulation
Side Wall
Shim
Fixing Angle
Cabinet
Guide
Cabinet
Guide
Asssembly
Cutout Width
Number of Metal Shims Required
22 1/8” (562mm)
0
22 3/16” (564mm)
2 total (1 on each side)
22 1/4” (566mm)
4 total (2 on each side)
22 3/8” (568mm)
6 total (3 on each side)
Front
Rear
Cabinet Glide Installation
I
nsTallIng
The
C
abIneT
g
lIDes
Cabinet Guide Assembly and Shims
