Dacor 36, Руководство по установке

Страница: 4 / 12

p
RoduCT
d
imensions
◊ The depth from the front of the door (w/o door handles) to
the back of the refrigerator chassis is 27 1/8” (689mm).
◊ The depth of the cabinet less door is 24” (610mm).
◊ The power cord is 40” (1016mm) long.
◊ The height from the top of the refrigerator to floor with the
leveling legs in the down position is 70 1/8” (1781mm)
◊ The height from the top of the refrigerator to floor with
d
esign
s
peCifiCaTions
i
nsTallaTion
s
peCifiCaTions
T
ools and
p
aRTs
IMPORTANT:
◊ Installer: Leave these Installation Instructions with the
homeowner.
◊ Homeowner: Keep these Installation Instructions for future
reference. Save these Installation Instructions for the local
electrical inspector’s use.
Tools needed:
Make sure that you have the necessary tools and materials
available for a proper installation.
◊ Phillips screwdriver set
◊ Slotted screwdriver set
◊ Torx drive screwdriver set
◊ Provide sufficient length 8’ (2.4m) to allow for a minimum of
a 24” (610mm) diameter service loop of 1/4” (6mm) copper
tubing and saddle valve for the water line (Do not use self-
piercing valves)
◊ Copper tubing cutter
◊ Level - 2’ (.6m) and 4’ (1.2m) recommended
◊ Appliance Dolly able to support 700lbs (317kg) and
adequate manpower to handle the weight of the appliance
◊ Various sized pliers
◊ Allen wrench set
◊ 3/8” hex bolt nut driver or socket set
◊ Crescent wrenches
◊ Cordless drill and assorted drill bits
l
oCaTion
R
equiRemenTs
Your Dacor
®
refrigerator can be recessed in an opening between
cabinets or installed at the end of a cabinet run using a side panel
to enclose the refrigerator.
WARNING
ExPLOSION HAzARD – Keep flammable material and vapors,
such as gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fir
e.
IMPORTANT:
◊ Observe all governing codes and ordinances.
◊ Do not install the refrigerator near an oven, radiator, or other
heat source, nor in a location where the temperature will fall
below 55° F (13 ° C).
◊ Floor must support the refrigerator weight, more than 600lbs
(272kg), door panels and contents of the refrigerator.
◊ Ceiling height must allow for side tipping radius.
◊ Location should permit doors to open fully.
the leveling legs in the fully extended position is 71 1/4”
( 1810 mm) at the front of the unit and 70 11/16” (1796mm) at
the rear of the unit.
◊ The width from the refrigerator from edge to is 35 5/8”
( 905 mm).
d
ooR
s
wing
d
imensions
The area to the left and the right of the appliance must permit
both doors to open to a minimum of 90°. Allow a minimum of 2
1/2” (64mm) space between the side of the refrigerator doors and
a corner wall.
◊ Masonite, plywood, 1/8” pressed fiberboard, cardboard or
other suitable material to protect finished flooring
◊ Appropriate materials to cover and protect the home and its
furnishings during installation