3.1 Pneumatic Controller Pre-Assembly
1.
Place Dabir Pneumatic Controller on a flat, stable surface, free and clear of loose articles which
could block the air intake.
CAUTION:
Do not block air intake ports on the bottom of the Pneumatic Control Unit or the
exhaust vent under the handle.
CAUTION:
Do not position Pneumatic Controller on top of loose articles which may
block air intake ports.
2.
Insert the Hose Assembly Connector (Male) into the receptacle of the Pneumatic Control Unit until
fully seated (see image below).
3.
Insert the four (4) Attachment Screws into the Hose Assembly Connector (Male) and tighten with
the provided Screwdriver.
CAUTION:
Do not over-tighten the Attachment Screws.
CAUTION:
Do not use petroleum based lubricants on the Hose Assembly Seals.
Use of these lubricants may cause the seals to swell and/or leak.
4.
Insert Power Cord as shown (see image below).
11
Low
Medium
High
CYCLE SPEED
Low
Medium
High
FIRMNESS
Information
Center
2
3
4
Hose Assembly
Connector (Male)
Power
Cord
Attachment
Screws (4)
Data Port for
Factory Use Only
Pneumatic
Controllor
Power
Cord
Hose Assembly
Connector (Male)
Data Port for
Factory Use
Only
Attach the Hose Assembly Connector
(Male) to the
Pneumatic Controller
using
the four (4) phillips head Attachment
Screws and Screwdriver provided.
DOC# R01-0006-00004-AA
Содержание DabirAIR CA-1001
Страница 32: ...DOC R01 0006 00004 AA...
