DAB NGPANEL, Инструкция по установке и обслуживанию

Страница: 50 / 63

ENGLISH
46
Once the control type has been configured, see section 8.2.4 Concluding configuration.
8.2.2 Floats
Indicate floats as the type of control.
Once you have made your choice, then indicate the polarity of your floats.
Once the control type has been configured, see section 8.2.4 Concluding configuration.
8.2.3 Level probes
Indicate the level probe as the type of control.
Once the control type has been configured, see section 8.2.4 Concluding configuration.
8.2.4 Concluding configuration
Pump exchange mode
One of the following intervals can be set:
- At restart
- Every 2 hours
- Every 4 hours
- Every 8 hours
- Every 12 hours
- Every 16 hours
- Every 20 hours
- Every 24 hours
- Never
The choice of exchange mode is necessary to prevent wear of
a single pump.
Enable water flow rate estimation function
To enable this function, refer to the chapter 8.2.5 Enabling water flow rate
estimation.
This option, which is only available when using the depth sensor, allows
you to monitor the amount of liquid in the tank.
If this function is not enabled during the Filling or
Draining Configuration, it can no longer be activated.This
will only be possible by resetting to the factory data
The system is ready
All the parameters have been set, the system is now in standby.
From here you can choose whether to access the "Main
Menu" or set the "Optional Configurations".
Refer to the respective chapters 8.5 Main menu and 8.4
Optional configurations.